Driving -> Stop and Start for Your Peugeot 208 4 Door 2020

Driving  
queues, etc.). The engine restarts automatically  
- START mode - as soon as the driver wishes to  
move off again.  
Primarily designed for urban use, the function  
is intended to reduce fuel consumption and  
exhaust emissions as well as the noise level  
when stationary.  
any risk of injury caused by the engine  
restarting automatically.  
Operation  
Depending on the driving situation and the  
vehicle's equipment, the system may advise  
skipping one or more gears.  
Gear engagement recommendations are only  
optional. In fact, the configuration of the road,  
the traffic density and safety remain determining  
factors when choosing the best gear. Therefore,  
the driver remains responsible for deciding  
whether or not to follow the system’s advice.  
This function cannot be deactivated.  
6
Driving on flooded roads  
The function does not affect the functionalities of  
the vehicle, in particular the braking.  
Before entering into a flooded area, it is  
strongly recommended that you deactivate  
the Stop & Start system.  
For more information on Driving  
recommendations, particularly on flooded  
roads, refer to the corresponding section.  
Deactivation/Reactivation  
The function is activated by default when the  
ignition is switched on.  
It is set via the Driving / Vehicle  
touch screen menu.  
A message in the instrument panel confirms the  
change of status.  
With an automatic gearbox, the system is  
only active in manual operation.  
The information appears in the instrument  
panel in the form of an arrow and the  
recommended gear.  
Operation  
Main conditions for operation  
When the function is deactivated, if the engine  
was in standby, it restarts immediately.  
The system adapts its gear shift  
recommendation according to the driving  
conditions (slope, load, etc.) and the driver’s  
requirements (power, acceleration, braking,  
etc.).  
The system never suggests:  
– engaging first gear,  
– engaging reverse.  
– The driver’s door must be closed.  
– The driver's seat belt must be fastened.  
– The state of charge of the battery must be  
sufficient.  
– The temperature of the engine must be within  
its nominal operating range.  
Associated indicator lamps  
Function activated.  
Function deactivated or malfunction.  
– The outside temperature must be between  
0°C and 35°C.  
Opening the bonnet  
Before doing anything under the bonnet,  
deactivate the Stop & Start system to avoid  
Putting the engine into standby  
(STOP mode)  
Stop & Start  
The Stop & Start function puts the engine  
temporarily into standby - STOP mode - during  
phases when the vehicle is stopped (red lights,  
The engine automatically goes into standby  
as soon as the driver indicates the intention of  
stopping.  
101  
Driving  
– With a manual gearbox: with the gear lever in  
neutral and the clutch pedal released.  
– With an automatic gearbox: with the brake  
pedal depressed until the vehicle stops or the  
gear selector in position N, with the vehicle  
stopped.  
Engine restarting (START mode)  
The vehicle stalls in STOP mode  
The engine automatically restarts as soon as the  
driver indicates the intention of moving off again.  
With a manual gearbox: with the clutch  
pedal fully depressed.  
With an automatic gearbox:  
• With the selector in position D or M: with the  
brake pedal released.  
• With the selector in position N and the brake  
pedal released: with the selector at D or M.  
• With the selector in position P and the brake  
pedal depressed: with the selector at R, N,  
D or M.  
All of the instrument panel warning lamps come  
on if there is a fault.  
► Switch off the ignition then start the engine  
again with the key or the "START/STOP" button.  
The Stop & Start system requires a 12 V  
battery of specific technology and  
specification.  
All work concerning the battery must be  
carried out only by a PEUGEOT dealer or a  
qualified workshop.  
Time counter  
A time counter adds up the time spent in standby  
during a journey. It resets to zero every time the  
ignition is switched on.  
Special cases:  
The engine will not go into standby if all of the  
conditions for operation are not met and in the  
following cases.  
– Steep slope (ascending or descending).  
– Vehicle has not exceeded 6 mph (10 km/h)  
since the last engine start (with the key or the  
START/STOP” button).  
– Needed to maintain a comfortable temperature  
in the passenger compartment.  
– Demisting active.  
• Reverse gear engaged.  
Under-inflation detection  
This system automatically checks the pressures  
of the tyres while driving.  
It compares the information given by the wheel  
speed sensors with reference values, which  
must be reinitialised every time the tyre  
pressures are adjusted or a wheel changed.  
The system triggers an alert as soon as it  
detects a drop in the inflation pressure of one or  
more tyres.  
Special cases  
The engine restarts automatically if all the  
operating conditions are met again and in the  
following cases.  
– With a manual gearbox: vehicle speed  
exceeds 2.5 mph (4 km/h),  
– With an automatic gearbox, in mode N, vehicle  
speed exceeds 0.6 mph (1 km/h).  
In these cases, this indicator lamp flashes  
for a few seconds, then goes off.  
In these cases, this indicator lamp flashes  
for a few seconds, then goes off.  
Under-inflation detection does not  
replace the need for vigilance on the part  
of the driver.  
This system does not avoid the need to  
regularly check the tyre pressures (including  
the spare wheel) as well as before a long  
journey.  
After the engine has restarted, STOP  
mode is not available until the vehicle  
has reached a speed of 5 mph (8 km/h).  
Malfunctions  
In the event of a malfunction, this warning  
lamp flashes for a few moments, then  
remains on, accompanied by an onscreen  
message.  
During parking manoeuvres, STOP mode  
is not available for a few seconds after  
coming out of reverse gear or turning the  
steering wheel.  
Have the vehicle checked by a PEUGEOT  
dealer or a qualified workshop.  
102