Practical information -> Energy economy mode for Your Peugeot 208 4 Door 2020

Practical information  
The snow chains must be fitted only to  
the front wheels. They must never be  
fitted to "space-saver" type spare wheels.  
It is strongly recommended that before  
you leave, you practise fitting the snow  
chains on a level and dry surface.  
Exiting the mode  
These functions are automatically reactivated the  
next time the vehicle is used.  
To restore the use of these functions  
Observe the legislation in force in your  
country on the use of snow chains and  
the maximum authorised speed.  
Avoid driving with snow chains on roads  
that have been cleared of snow to avoid  
damaging the vehicle's tyres and the road  
surface. If the vehicle is fitted with alloy  
wheels, check that no part of the chain or its  
fixings is in contact with the wheel rim.  
immediately, start the engine and let it run:  
– For less than 10 minutes, to use the  
equipment for approximately 5 minutes.  
– For more than 10 minutes, to use the  
equipment for approximately 30 minutes.  
Let the engine run for the specified duration to  
ensure that the battery charge is sufficient.  
To recharge the battery, avoid repeatedly or  
continuously restarting the engine.  
Use only chains designed to be fitted to the type  
of wheel fitted to the vehicle:  
Original tyre size  
185/65 R15  
Maximum link size  
9 mm  
Energy economy mode  
195/55 R16  
9 mm  
This system manages the duration of use of  
certain functions, in order to conserve a sufficient  
level of charge in the battery with the ignition off.  
After switching off the engine, you can still  
use functions such as the audio and telematic  
system, the wipers and the dipped beam  
headlamps or courtesy lamps, for a combined  
duration of approximately 40 minutes.  
A flat battery prevents the engine from  
starting.  
For more information on the 12 V battery,  
refer to the corresponding section.  
205/45 R17  
Not suitable for  
chains  
For more information on snow chains, contact a  
PEUGEOT dealer or a qualified workshop.  
Installation tips  
Load reduction mode  
This system manages the use of certain  
functions according to the level of charge  
remaining in the battery.  
When the vehicle is being driven, the load  
reduction function temporarily deactivates certain  
functions, such as the air conditioning and the  
heated rear screen.  
The deactivated functions are reactivated  
automatically as soon as conditions permit.  
To t the chains during a journey, stop the  
vehicle on a flat surface on the side of the road.  
► Apply the parking brake and position any  
wheel chocks under the wheels to prevent  
movement of the vehicle.  
Selecting the mode  
A confirmation message is displayed when  
energy economy mode is entered, and the active  
functions are placed on standby.  
► Fit the chains following the instructions  
provided by the manufacturer.  
► Move off gently and drive for a few moments,  
without exceeding 31 mph (50 km/h).  
► Stop the vehicle and check that the snow  
chains are correctly tightened.  
If a telephone call is in progress at the  
time, it will be maintained for around 10  
minutes via the audio system’s hands-free  
system.  
152