Access -> Electric windows for Your Peugeot 3008 SUV 2020

Access  
– Changing a wheel.  
Towing the vehicle.  
– Transport on a ship or ferry.  
Have it checked by a PEUGEOT dealer or a  
qualified workshop.  
Triggering of the alarm  
This is indicated by sounding of the siren  
and flashing of the direction indicators for 30  
seconds.  
Depending on the country of sale, certain  
monitoring functions remain active until the alarm  
has been triggered eleven times consecutively.  
When the vehicle is unlocked using the remote  
control or the Keyless Entry and Starting system,  
rapid flashing of the red indicator lamp in the  
button informs you that the alarm was triggered  
during your absence. When the ignition is  
switched on, this flashing stops.  
Electric windows  
Deactivating the interior volumetric  
and anti-tilt monitoring  
► Switch off the ignition and within 10 seconds  
press the alarm button until its red indicator lamp  
is on fixed.  
► Get out of the vehicle.  
► Immediately lock the vehicle using the remote  
control or the Keyless Entry and Starting system.  
Only the exterior perimeter monitoring is  
activated; the button's red indicator lamp flashes  
once every second.  
1. Left-hand front  
2. Right-hand front  
3. Right-hand rear  
4. Left-hand rear  
5. Deactivation of electric window controls  
located by rear seats  
Failure of the remote control  
To deactivate the monitoring functions:  
► Unlock the vehicle using the key in the  
driver's door lock.  
► Open the door; the alarm is triggered.  
► Switch on the ignition; this stops the alarm.  
The indicator lamp in the button goes off.  
To take effect, this deactivation must be  
carried out after each time the ignition is  
switched off.  
Manual operation  
To open/close the window, press/pull the  
switch without passing the point of resistance;  
the window stops as soon as the switch is  
released.  
Reactivating the interior volumetric  
and anti-tilt monitoring  
► Deactivate the exterior perimeter monitoring  
by unlocking the vehicle using the remote control  
or the Keyless Entry and Starting system.  
The indicator lamp in the button goes off.  
► Reactivate all monitoring by locking the  
vehicle using the remote control or the Keyless  
Entry and Starting system.  
Locking the vehicle without  
activating the alarm  
► Lock or deadlock the vehicle using the key  
(built-in the remote control) in the driver's door  
lock.  
Automatic operation  
To open/close the window, press/pull the  
switch past its resistance point: the window  
opens/closes completely when the switch is  
released.  
Malfunction  
When the ignition is switched on, the fixed  
lighting of the red indicator lamp in the button  
indicates a system malfunction.  
Operating the switch again stops the movement  
of the window.  
The red indicator lamp in the button once again  
flashes every second.  
38  
Access  
Do not put your head or arms through the  
open windows when the vehicle is moving -  
risk of serious injury!  
Window controls remain operational for  
approximately 45 seconds after switching  
off the ignition or after locking the vehicle.  
After that time, the controls are disabled.  
To reactivate them, switch on the ignition or  
unlock the vehicle.  
Reinitialising the electric  
windows  
After reconnecting the battery, or in the event  
of abnormal window movement, the anti-pinch  
function must be reinitialised.  
The anti-pinch function is disabled during the  
following sequence of operations.  
For each window:  
► Lower the window fully, then raise it; it will  
rise in steps of a few centimetres each time the  
control is pressed. Repeat the operation until the  
window is fully closed.  
2
Panoramic sunroof  
The panoramic sunroof consists of a movable  
glass panel that slides over the roof and a blind  
that can be opened independently. Opening the  
sunroof automatically opens the blind.  
Anti-pinch  
If the window meets an obstacle while rising, it  
stops and immediately partially lowers again.  
To operate the panoramic sunroof or the  
blind, use the buttons in the roof console.  
Deactivating the rear  
controls for the rear electric  
windows  
► Continue to pull the control for at least one  
second after the window reaches the closed  
position.  
If an electric window meets an obstacle  
during operation, the movement of the  
window must be reversed. To do this, press  
the relevant control.  
When the driver operates the passengers’  
electric window controls, it is important to  
ensure that nothing can prevent the window  
from closing properly.  
It is important to ensure that passengers use  
the electric windows correctly.  
Pay particular attention to children when  
operating the windows.  
Be aware of passengers and/or other persons  
present when closing windows using the key  
or the "Keyless Entry and Starting" system.  
For your children's safety, press control 5 to  
deactivate the controls for the rear electric  
windows, irrespective of their positions.  
The red indicator lamp in the button comes  
on and a confirmation message is displayed.  
The lamp will remain lit until the controls are  
reactivated.  
A. Sunroof blind control  
B. Sunroof control  
The sunroof or blind can be operated when the  
ignition is turned on (if the battery is charged  
enough), with the engine running, in STOP mode  
of Stop & Start, and up to 45 seconds after  
turning off the ignition or after locking the vehicle.  
The rear electric windows can still be controlled  
using the driver's controls.  
39