Access -> Panoramic sunroof for Your Peugeot 3008 SUV 2020

Access  
Do not put your head or arms through the  
open windows when the vehicle is moving -  
risk of serious injury!  
Window controls remain operational for  
approximately 45 seconds after switching  
off the ignition or after locking the vehicle.  
After that time, the controls are disabled.  
To reactivate them, switch on the ignition or  
unlock the vehicle.  
Reinitialising the electric  
windows  
After reconnecting the battery, or in the event  
of abnormal window movement, the anti-pinch  
function must be reinitialised.  
The anti-pinch function is disabled during the  
following sequence of operations.  
For each window:  
► Lower the window fully, then raise it; it will  
rise in steps of a few centimetres each time the  
control is pressed. Repeat the operation until the  
window is fully closed.  
2
Panoramic sunroof  
The panoramic sunroof consists of a movable  
glass panel that slides over the roof and a blind  
that can be opened independently. Opening the  
sunroof automatically opens the blind.  
Anti-pinch  
If the window meets an obstacle while rising, it  
stops and immediately partially lowers again.  
To operate the panoramic sunroof or the  
blind, use the buttons in the roof console.  
Deactivating the rear  
controls for the rear electric  
windows  
► Continue to pull the control for at least one  
second after the window reaches the closed  
position.  
If an electric window meets an obstacle  
during operation, the movement of the  
window must be reversed. To do this, press  
the relevant control.  
When the driver operates the passengers’  
electric window controls, it is important to  
ensure that nothing can prevent the window  
from closing properly.  
It is important to ensure that passengers use  
the electric windows correctly.  
Pay particular attention to children when  
operating the windows.  
Be aware of passengers and/or other persons  
present when closing windows using the key  
or the "Keyless Entry and Starting" system.  
For your children's safety, press control 5 to  
deactivate the controls for the rear electric  
windows, irrespective of their positions.  
The red indicator lamp in the button comes  
on and a confirmation message is displayed.  
The lamp will remain lit until the controls are  
reactivated.  
A. Sunroof blind control  
B. Sunroof control  
The sunroof or blind can be operated when the  
ignition is turned on (if the battery is charged  
enough), with the engine running, in STOP mode  
of Stop & Start, and up to 45 seconds after  
turning off the ignition or after locking the vehicle.  
The rear electric windows can still be controlled  
using the driver's controls.  
39  
Access  
Precautions  
To close the sunroof or the blind, use the part  
of the button located towards the front of the  
vehicle.  
Operation  
When opening the sunroof fully, the movable  
glass moves to a partially open position, then  
slides over the roof. Any intermediate position is  
possible.  
Do not put your head or arms through the  
sunroof while the vehicle is moving - risk  
of serious injury!  
Operation of buttons  
► Pressing a button beyond its point of  
resistance directly opens or closes the sunroof  
or blind fully.  
► Pressing the button again stops the current  
movement.  
► When holding a button (without going  
beyond the point of resistance), the movement  
of the sunroof or blind stops when this button is  
released.  
► When the sunroof is closed: pressing once  
without passing the point of resistance moves it  
to a partially open position.  
Depending on the speed of the vehicle,  
the partially open position may vary to  
improve the acoustics.  
Ensure that any luggage or accessories  
carried on the roof bars do not interfere  
with the movement of the sunroof.  
Do not place heavy loads on the movable  
glass panel of the sunroof.  
Before operating the sunroof or blind  
control buttons, ensure that no object or  
person might prevent the movement.  
Be particularly aware of children when  
operating the sunroof or blind.  
If something is trapped when operating the  
sunroof or blind, you should reverse the  
movement of the sunroof or blind by pressing  
the control in question.  
If the sunroof is wet, following a shower  
or washing the vehicle, wait until it is  
completely dry before opening.  
Do not operate the sunroof if it is covered by  
snow or ice - risk of damage!  
► When the sunroof is partially open: pressing  
once without passing the point of resistance  
opens or closes it fully.  
Use only plastic scrapers to remove snow or  
ice from the sunroof.  
The driver must ensure that passengers use  
the sunroof and blind correctly.  
The sunroof and windows, then the blind,  
can be closed by holding down the door  
locking control. The manoeuvre stops as soon  
as the locking control is released.  
Regularly check the condition of the  
sunroof seals (e.g. presence of dust,  
dead leaves).  
If using a car wash, check first that the roof is  
correctly closed and keep the high-pressure  
jet at least 30 centimetres from the seals.  
Anti-pinch system  
If the sunroof or blind encounters an obstacle  
when closing, the movement is automatically  
reversed.  
The roof anti-pinch system is designed to be  
effective at speeds of up to 75 mph (120 km/h).  
Closing of the blind is limited by the  
position of the sunroof: the blind cannot  
go further than the front of the movable glass.  
During simultaneous movements of the  
sunroof and blind, the blind automatically  
stops or resumes movement depending on  
the position of the sunroof.  
Never leave the vehicle with the sunroof  
open.  
Opening/Closing  
To open the sunroof or the blind, use the  
part of the button located towards the rear of the  
vehicle.  
40  
Access  
Reinitialisation  
Following reconnection of the battery or in the  
event of a fault or jerky movement of the sunroof  
or blind, reinitialisation is required.  
2
► Check that nothing is interfering with the  
sunroof or blind and that the seals are clean.  
► With the ignition on, fully close the sunroof  
and blind.  
► Press and hold the front part of button B, until  
the sunroof and blind move slightly, then hold for  
a further 1 second before releasing.  
► Wait 2 seconds and then press and hold the  
front part of button B. The blind and the sunroof  
will open and close, one after the other. When  
both are completely closed again, hold for a  
further 2 seconds and release.  
If there is an operating fault, restart the  
whole procedure.  
41