Ease of use and comfort -> Rear fittings for Your Peugeot 3008 SUV 2020

Ease of use and comfort  
In "Permanent lighting" mode, the lighting time  
varies according to the circumstances:  
– With the ignition off, approximately 10 minutes.  
– In energy saving mode, approximately 30  
seconds.  
Rear fittings  
12 V accessory socket  
– With the engine running, unlimited.  
When the front courtesy lamp is in the  
"Permanent lighting" position, the rear  
courtesy lamp also comes on, unless it is in  
the "Permanently off" position.  
To switch off the rear courtesy lamp, put it in  
the "Permanently off" position.  
3. Rear courtesy lamp  
4. Rear reading lamps  
To connect a 12 V accessory (maximum  
power: 120 W), lift the cover and plug in a  
suitable adaptor.  
Reading lamps  
Front and rear courtesy  
lamps  
► With the ignition on, operate the  
The connection of an electrical device  
not approved by PEUGEOT, such as a  
USB charger, may adversely affect the  
operation of vehicle electrical systems,  
causing faults such as poor radio reception or  
interference with displays in the screens.  
corresponding switch.  
In this position, the courtesy lamp comes  
on gradually:  
Do not place anything against the  
courtesy lamps.  
– when the vehicle is unlocked.  
– when the key is removed from the ignition  
switch.  
– when a door is opened.  
Interior ambient lighting  
– when the remote control locking button is  
activated, in order to locate the vehicle.  
It switches off gradually:  
– when the vehicle is locked.  
– when the ignition is switched on.  
– 30 seconds after the last door is closed.  
Permanently off.  
The dimmed passenger compartment lighting  
improves visibility in the vehicle when the light  
is poor.  
At night, the ambient lighting comes on/goes off  
automatically when the sidelamps are switched  
on/off.  
Activation / deactivation and adjustment  
of the light intensity are set via the  
Driving / Vehicle touch screen menu.  
Permanent lighting.  
66  
Ease of use and comfort  
The armrest incorporates two cup holders.  
USB sockets  
"Aircraft" type tables  
3
Ski flap  
Device for storing and transporting long objects.  
Opening  
► With the rear armrest lowered, open the flap  
by pulling its handle downwards.  
Each USB socket is used only to power or  
recharge a portable device.  
Rear armrest  
To use the table, lower it fully until it locks in  
the low position.  
To store it, raise the table to the high position,  
passing the point of resistance.  
On the passenger side, do not forget to  
fold it before placing the backrest in the  
"table" position.  
For more information on the Front seats, and  
in particular placing the backrest in the "table"  
position, refer to the corresponding section.  
► Load the objects from inside the boot.  
Do not place hard or heavy objects on  
the table.  
They could become dangerous projectiles in  
the event of emergency braking or impact.  
67  
Ease of use and comfort  
Side blinds  
2. 12V accessory socket (max. 120W)  
3. Boot lamp  
4. Rear seat folding controls  
5. Hooks  
6. Stowing rings  
7. Boot floor  
8. Storage well/Tool box under the floor  
9. Open storage compartments  
Depending on version, the storage boxes are  
fitted in the floor, at the foot of the side seats on  
the second row.  
On the left-hand side, it may also contain the  
temporary puncture repair kit.  
To open them, lift the cover by the notch.  
Boot fittings  
Fitted to the second row windows, they protect  
the passenger compartment from the sun's rays.  
► Pull the central tab to unroll the blind.  
► Position the blind's clip on the hook.  
Always guide the blind slowly, using the  
tab, while raising or lowering it.  
1. Load space cover roller  
2. 12 V accessory socket (max. 120 W)  
3. Boot lamp  
Storage boxes  
4. Luggage retaining strap  
5. Storage brackets of the load space cover  
roller  
6. Armrest with cup holder and storage  
compartment  
7. Open storage compartment  
1. Load space cover shelf  
68