Get In the event of a breakdown -> Tool kit Guide for Peugeot 3008 SUV 2020

In the event of a breakdown

2.0 HDi engines

With temporary puncture repair kit

► Open the bonnet and then, if necessary,

unclip the cover to access the priming pump.

► Loosen the degassing bolt.

► Operate the priming pump until fuel

appears in the transparent tube.

► Retighten the degassing bolt.

► Operate the starter motor until the engine

starts (if the engine does not start at the ﬁrst

attempt, wait around 15 seconds before trying

again).

► If the engine does not start after a few

attempts, operate the priming pump again, then

the starter motor.

► Unclip the two ﬁxings to open its cover.

► Put the cover back in place and clip it in, then

close the bonnet.

With spare wheel

The tool kit is stored in the boot, under the ﬂoor.

To access it:

Versions with 2-position boot ﬂoor:

► Open the boot.

► Place the adjustable boot ﬂoor in the high

position.

► Lift the boot ﬂoor past the two retractable

stops.

Tool kit

Set of tools supplied with the vehicle.

Its content depends on your vehicle's equipment:

– Temporary puncture repair kit.

– Spare wheel.

► Place the boot ﬂoor onto these two stops to

hold it up.

Accessing the tools

Versions with articulated boot mat

(Rechargeable hybrid):

► Open the boot.

► Unfold the articulated boot mat by pulling its

handle until it is fully opened.

► Unclip the storage box by pulling it upwards.

► Unclip the two ﬁxings to open its cover.

190

In the event of a breakdown

With temporary puncture repair kit

The tool box is installed at the centre of the

spare wheel beneath the vehicle.

It contains the jack and the wheel bolt cover

removal tool.

Accessing the tools

► First, access the spare wheel.

For further information on the Spare wheel,

please refer to the corresponding section.

► Press the tab to unlock the cover.

► While keeping the tab pressed in, slide the

cover to the middle and remove it.

Model without storage box

This kit, stored in a bag, is installed behind the

second row left-hand seat.

► Fold the seat backrest onto the cushion to

access the bag.

List of tools

Some of the tools are stored beneath the ﬂoor

against the boot sill.

The left-hand box contains the wheelbrace and

its extension piece.

Model with storage box

The right-hand box contains the wheel chocks

and the towing eye.

To access it:

This kit is installed in the storage box, located in

front of the second row left-hand seat.

► Open the storage box cover to access the kit.

► Open the boot.

With spare wheel

► Fold the concertina panels.

► Install the third row seats.

► Unclip the required tools from the boot sill

trim.

1. Chocks to immobilise the vehicle (depending

on equipment)

2. Socket for the wheel security bolts (located in

the glove box) (depending on equipment)

To adapt the wheelbrace to the special

‘security’ bolts.

3. Removable towing eye

191

In the event of a breakdown

For more information on Towing the vehicle

and using the removable towing eye, refer to the

corresponding section.

With spare wheel

These tools are speciﬁc to the vehicle

and may vary according to the level of

equipment.

Do not use them for any other purpose.

With temporary puncture repair kit

Kit 1

The jack must only be used to change a

wheel with a damaged or punctured tyre.

Do not use any jack other than the one

supplied with the vehicle.

If the vehicle does not have its original jack,

contact a PEUGEOT dealer or a qualiﬁed

workshop to obtain the one that was intended

by the manufacturer.

The jack meets European standards, as

deﬁned in the Machinery Directive 2006/42/

CE.

5. Wheelbrace

Kit 2

For removing the wheel trim and the wheel

bolts.

6. Jack with integrated handle

The jack does not require any maintenance.

To raise the vehicle.

7. Wheel bolt cap removal tool (depending on

Temporary puncture

repair kit

equipment)

For removing the wheel bolt head ﬁnishers on

alloy wheels.

Scan the QR Code on page 3 to view

explanatory videos.

4. 12 V compressor with cartridge of sealant

and speed limit sticker

Made up of a compressor and a sealant

cartridge, it allows you to carry out a temporary

repair of the tyre so that you can drive to the

nearest garage.

Wheelbrace extension

For loosening/tightening the spare wheel

carrier winch cable nut.

For temporary repair of a tyre and to adjust

the tyre pressure.

It is designed to repair most punctures located

on the tyre tread.

For more information on the Spare wheel, refer

to the corresponding section.

For more information about the Temporary

puncture repair kit, refer to the corresponding

section.

192

In the event of a breakdown -> Tool kit for Your Peugeot 3008 SUV 2020

Popular Manuals