Lighting and visibility -> Wiper control stalk for Your Peugeot 3008 SUV 2020

Lighting and visibility  
– Camera masked by snow, mud or dust.  
– Camera scratched after going through roller  
car washes repeatedly.  
– Very high outside temperature.  
– At the top or bottom of a steep slope.  
– On a very winding road.  
Wiper control stalk  
Before operating the wipers in wintry  
conditions, clear any snow, ice or frost  
from the windscreen and around the wiper  
arms and blades.  
– In a bend.  
– After an impact which may have impaired the  
camera settings or damaged it.  
– After repainting of the grille outside of the  
PEUGEOT dealer network or a qualified  
workshop.  
Do not operate the wipers on a dry  
windscreen. In extremely hot or cold  
weather, check that the wiper blades are not  
stuck to the windscreen before operating the  
wipers.  
The camera detection range is between 15 m  
(for pedestrians) and 200 m, depending on  
visibility conditions.  
The image provided by the camera is displayed  
in shades of grey in the instrument panel; warm  
objects appear brighter than cold objects.  
If pedestrians or animals are detected, they  
appear in yellow frames.  
Maintenance  
recommendations  
The infrared camera has a wash nozzle  
connected to the vehicle’s front screenwash  
system.  
This nozzle operates every 5th use of the  
screenwash.  
Regularly check that the camera is clean.  
In bad weather, or in wintry conditions, ensure  
that the camera is not covered with mud, ice or  
snow.  
After using an automatic car wash, you  
may temporarily notice abnormal noises  
and poorer wiping performance. You do not  
need to replace the wiper blades.  
If the system detects a risk of  
collision with pedestrians or  
animals, it triggers an alert: one of these symbols  
appears on the instrument panel. The  
corresponding silhouette is framed in red.  
If the "Night Vision" display mode has not been  
selected, the alert is triggered in the form of a  
temporary window.  
Windscreen wipers  
In the event of an alert, the driver may act by  
making an avoiding manoeuvre or by braking.  
Malfunction  
Operating limits  
The following situations may interfere with  
the operation of the system or prevent it from  
working:  
If the event of a malfunction, this warning  
lamp comes on in orange on the  
instrument panel, accompanied by the display of  
a message.  
To select the wiping speed: raise or lower the  
stalk to the desired position.  
– Poor visibility conditions (falling snow, heavy  
rain, thick fog).  
Have it checked by a PEUGEOT dealer or a  
qualified workshop.  
80  
Lighting and visibility  
Fast wiping (heavy rain)  
Off  
Windscreen wash  
4
► Pull the wiper control stalk towards you and  
hold.  
Normal wiping (moderate rain)  
Intermittent wiping  
Screenwash-wipe  
A final wiping cycle is performed when  
screenwashing ends.  
Intermittent wiping (proportional to the  
vehicle’s speed)  
The windscreen wash jets are  
incorporated into the tip of each wiper  
arm.  
Screenwash fluid is sprayed along the length  
of the wiper blade. This improves visibility and  
reduces screenwash fluid consumption.  
Switching off  
Reverse gear  
Automatic wiping  
When reverse gear is engaged, the rear wiper  
will come into operation automatically if the front  
windscreen wipers are operating.  
Refer to the corresponding section.  
The settings are changed via the Driving/  
Vehicle touch screen menu.  
Single wipe  
► Pull the stalk briefly towards you.  
To avoid damaging the wiper blades, do  
not operate the screenwash if the  
screenwash reservoir is empty.  
Only operate the screenwash if there is no  
risk of the fluid freezing on the windscreen  
and hindering visibility. During the winter  
period, use "very cold climate" rated products.  
Never top up with water.  
In the event of accumulation of snow or  
hard frost or if a bicycle carrier is fitted to  
a towing device, deactivate the automatic rear  
wiper via the vehicle configuration menu.  
In position 1 or 2, the wiping frequency is  
automatically reduced when the speed of  
the vehicle drops below 3 mph (5 km/h).  
When the speed is above 6 mph (10 km/h)  
again, the wiping frequency returns to the  
original frequency (fast or normal).  
Rear screenwash  
► Turn the ring all the way towards the  
dashboard and hold.  
The screenwash and the wiper operate for as  
long as the ring remains turned.  
A final wiping cycle is performed when  
screenwashing ends.  
Ha a gyújtást úgy vették le, hogy az  
ablaktörlők jártak, működtesse újra a kart  
a törlés ismételt bekapcsolásához, amint  
visszakapcsolta a gyújtást (kivéve, ha a  
gyújtás levétele egy percen belül történt).  
Rear wiper  
Automatic windscreen  
wipers  
In AUTO mode, the windscreen wipers work  
automatically and adapt to the intensity of the  
rain.  
After switching off the ignition, a slight  
movement of the windscreen wipers to  
store them under the bonnet may occur.  
Turn the ring to align the desired symbol with  
the marking.  
81