Practical information -> Motorhazteto for Your Peugeot 3008 SUV 2020

Practical information  
If a telephone call is in progress at the  
time, it will be maintained for around 10  
minutes via the audio system’s hands-free  
system.  
functions, such as the air conditioning and the  
heated rear screen.  
The deactivated functions are reactivated  
automatically as soon as conditions permit.  
opened when the left-hand front door is  
closed.  
7
When the engine is hot, handle the  
exterior safety catch and the bonnet stay  
with care (risk of burns), using the protected  
area.  
When the bonnet is open, take care not to  
damage the safety catch.  
Motorháztető  
Exiting the mode  
These functions are automatically reactivated the  
next time the vehicle is used.  
Stop & Start  
Before doing anything under the bonnet,  
you must switch off the ignition to avoid any  
risk of injury resulting from an automatic  
change to START mode.  
To restore the use of these functions  
Do not open the bonnet under very windy  
conditions.  
immediately, start the engine and let it run:  
– For less than 10 minutes, to use the  
equipment for approximately 5 minutes.  
– For more than 10 minutes, to use the  
equipment for approximately 30 minutes.  
Let the engine run for the specified duration to  
ensure that the battery charge is sufficient.  
To recharge the battery, avoid repeatedly or  
continuously restarting the engine.  
Cooling of the engine when stopped  
The engine cooling fan may start after  
the engine has been switched off.  
Take care with objects or clothing that  
could be caught in the blades of the fan!  
Rechargeable hybrid vehicles  
Before any work is carried out under the  
bonnet, it is essential to switch off the ignition  
and disconnect the charging connector nozzle  
if it is connected, check that the READY  
indicator lamp is off on the instrument panel  
and wait 4 minutes - risk of serious injury!  
Opening  
A flat battery prevents the engine from  
starting.  
For more information on the 12 V battery,  
refer to the corresponding section.  
Load reduction mode  
This system manages the use of certain  
functions according to the level of charge  
remaining in the battery.  
When the vehicle is being driven, the load  
reduction function temporarily deactivates certain  
The location of the interior bonnet  
release lever prevents the bonnet being  
► Open the left-hand front door.  
179  
Practical information  
► Pull the interior release lever, located at the  
bottom of the door frame, towards you.  
Petrol engine  
Closing  
► Hold the bonnet and pull out the stay from the  
support slot.  
► Clip the stay in its housing.  
► Lower the bonnet and release it near the end  
of its travel.  
► Pull on the bonnet to check that it is locked  
correctly.  
Because of the presence of electrical  
equipment under the bonnet, it is strongly  
recommended that exposure to water (rain,  
washing, etc.) be limited.  
Diesel engine  
► Lift the exterior safety catch and raise the  
bonnet.  
Engine compartment  
The engine shown here is an example for  
illustrative purposes only.  
The locations of the following elements may  
vary:  
1. Screenwash fluid reservoir  
2. Engine coolant reservoir  
3. Brake fluid reservoir  
4. Battery/Fuses  
5. Remote earth point (-)  
6. Fusebox  
– Air filter.  
– Engine oil dipstick.  
– Engine oil filler cap.  
– Priming pump.  
7. Air filter  
– Degassing screw.  
8. Engine oil filler cap  
9. Engine oil dipstick  
10. Priming pump*  
► Unclip the stay from its housing and place it  
in the support slot to hold the bonnet open.  
11. Degassing screw*  
* Depending on engine.  
180