Practical information -> Snow chains for Your Peugeot 3008 SUV 2020

Practical information  
These points are concealed by the vehicle doors  
when the doors are closed.  
The roof bar fixings have a stud which must be  
inserted into the opening of each fixing point.  
Remove the roof bars once they are no longer  
needed.  
Original tyre size  
Maximum link size  
7
235/50 R19  
Not suitable for  
chains  
Sunroof  
Check that the load does not pass below  
the roof bars so that it does not impede the  
movements of the sunroof - risk of major  
damage!  
Maximum load distributed over the  
transverse roof bars, for a loading height  
not exceeding 40 cm (except bicycle carrier):  
80 kg.  
As this value may change, please verify the  
maximum load quoted in the guide supplied  
with the roof bars.  
If the height exceeds 40 cm, adapt the speed  
of the vehicle to the profile of the road to  
avoid damaging the roof bars and the fixings  
on the vehicle.  
Be sure to refer to national legislation in order  
to comply with the regulations for transporting  
objects that are longer than the vehicle.  
For more information on snow chains, contact a  
PEUGEOT dealer or a qualified workshop.  
Installation tips  
To t the snow chains during a journey, stop  
the vehicle on a flat surface at the side of the  
road.  
► Apply the parking brake and position any  
wheel chocks under the wheels to prevent  
movement of the vehicle.  
► Fit the snow chains following the instructions  
provided by the manufacturer.  
► Move off gently and drive for a few moments,  
without exceeding 31 mph (50 km/h).  
► Stop the vehicle and check that the snow  
chains are correctly tightened.  
Snow chains  
In wintry conditions, snow chains improve  
traction as well as the behaviour of the vehicle  
when braking.  
Snow chains must be fitted only to the  
front wheels. They must never be fitted to  
"space-saver" type spare wheels.  
Observe the legislation in force in your  
country relating to the use of snow  
chains and maximum authorised speeds.  
Recommendations  
Distribute the load uniformly, taking care  
to avoid overloading one of the sides.  
Arrange the heaviest part of the load as close  
as possible to the roof.  
It is strongly recommended that you  
practise fitting the snow chains on a level  
and dry surface before setting off.  
Use only chains designed to be fitted to the type  
of wheel fitted to the vehicle:  
Secure the load firmly.  
Avoid driving with snow chains on roads  
that have been cleared of snow to avoid  
damaging the vehicle's tyres and the road  
surface. If the vehicle is fitted with alloy  
wheels, check that no part of the chain or its  
fixings is in contact with the wheel rim.  
Original tyre size  
215/65 R17  
Maximum link size  
Drive gently: the vehicle will be more  
susceptible to the effects of side winds and its  
stability may be affected.  
Regularly check the security and tight  
fastening of the roof bars, at least before each  
trip.  
9 mm  
9 mm  
9 mm  
225/55 R18  
205/55 R19  
177  
Practical information  
Rechargeable hybrid vehicles  
The use of snow chains is only  
authorised on the front wheels.  
Before any operation, ensure that the  
engine is off and the cooling fan has  
stopped.  
Removing  
The driving mode selector must be on the  
4WD position (depending on version).  
It is essential to remove them when:  
– the outside temperature exceeds  
10°C.  
Very cold climate screen  
(Depending on country of sale)  
This removable device prevents the  
accumulation of snow around the radiator  
cooling fan.  
– recovery is in progress.  
– the speed is above 75 mph (120 km/h).  
Fitting  
► Insert a finger into the notch in the upper part  
of the screen.  
► Pull towards you to unclip the unit.  
Repeat these operations for the other screen.  
It consists of two elements to be attached to the  
front bumper.  
Energy economy mode  
This system manages the duration of use of  
certain functions, in order to conserve a sufficient  
level of charge in the battery with the ignition off.  
After switching off the engine and for a maximum  
cumulative period of around 30 minutes, you can  
continue to use functions such as the audio and  
telematics system, dipped beam headlamps or  
courtesy lamps.  
► Hold the corresponding screen in front of the  
lower grille of the bumper.  
► First insert the upper and side fixing brackets  
into the bumper.  
► Tilt the screen downwards to engage the  
lower part of the screen into the bumper.  
► Check that the unit is firmly held by pressing  
around the edges.  
In case of difficulty with installation/  
removal  
Contact a PEUGEOT dealer or a qualified  
workshop.  
Selecting the mode  
A confirmation message is displayed when  
energy economy mode is entered, and the active  
functions are placed on standby.  
Repeat these operations for the other screen.  
178