Get Access -> Alarm Guide for Peugeot 3008 SUV Third Generation (2024-2025)

Access

System which protects and provides a deterrent

against theft and break-ins.

Boot

Exterior perimeter monitoring

Opening

► After unlocking the vehicle or just the boot

(depending on version), press the opening

control and then lift the tailgate.

The system checks for opening of the vehicle.

The alarm is triggered if anyone tries to open a

door, the boot or the bonnet, for example.

Interior volumetric monitoring

► Insert a small screwdriver into hole A of the

lock to unlock the boot.

► Move the latch to the left.

Closing

► Lower the tailgate using one of the interior

grab handles.

The system checks for any variation in volume in

the passenger compartment.

The alarm is triggered if anyone breaks a

window, enters the passenger compartment or

moves inside the vehicle.

In the event of a malfunction or if you

experience diﬃculty opening or closing

the tailgate, have it checked by a PEUGEOT

dealer or a qualiﬁed workshop without delay,

to avoid the issue deteriorating and prevent

any risk of the tailgate dropping, potentially

causing serious injury.

Locking after closing

If the fault persists after closing again, the boot

will remain locked.

Anti-tilt monitoring

The system checks for any change in the attitude

of the vehicle.

The alarm goes oﬀ if the vehicle is lifted or

moved.

In the event of a fault with the central

locking system, it is essential to

disconnect the battery to lock the boot and so

ensure complete locking of the vehicle.

When the vehicle is parked, the alarm

will not be triggered if the vehicle is

knocked.

Back-up release

To manually unlock the boot in the event of a

battery or central locking failure.

Alarm

(Depending on version)

Self-protection function

Unlocking

► Fold the rear seats to gain access to the lock

The system checks whether any of its

components are out of service.

from inside the boot.

The alarm is triggered if the battery, the central

control or the siren wiring is put out of service or

damaged.

Work on the alarm system

Consult a PEUGEOT dealer or a

qualiﬁed workshop.

CarManuals2.com

Access

The monitoring system is deactivated: the

indicator lamp in the button goes oﬀ and the

sidelamps and/or the daytime running lamps

ﬂash for about 2 seconds.

Only the exterior perimeter monitoring is

activated; the button's red indicator lamp ﬂashes

once every second.

Locking the vehicle with full

alarm system

To take eﬀect, this deactivation must be

carried out after each time the ignition is

switched oﬀ.

Activation

After unlocking using the remote

control

If the vehicle automatically locks itself again

(as happens if a door or the boot is not

opened within 30 seconds of unlocking), the

monitoring system is automatically activated.

► Switch oﬀ the ignition and exit the vehicle.

► Lock or deadlock the vehicle using the

remote control or by pressing on the driver's

door handle.

When the monitoring system is active, the red

indicator lamp in the button ﬂashes once per

second and the direction indicators come on for

about 2 seconds.

Reactivating the interior volumetric

and anti-tilt monitoring

► Deactivate the exterior perimeter monitoring

by unlocking the vehicle using the remote control

or the Keyless Entry and Start system.

The indicator lamp in the button goes oﬀ.

► Reactivate all monitoring by locking the

vehicle using the remote control or the Keyless

Entry and Start system.

Locking the vehicle

with exterior perimeter

monitoring only

Deactivate the interior volumetric and anti-tilt

monitoring to avoid the unwanted triggering of

the alarm, in certain cases such as:

– Slightly open window.

– Washing the vehicle.

– Changing a wheel.

– Towing the vehicle.

– Transport on a ship or ferry.

The exterior perimeter monitoring is activated

after 5 seconds and the interior volumetric and

anti-tilt monitoring after 45 seconds.

The alarm does not activate when

locking automatically from a distance.

The red indicator lamp in the button once again

ﬂashes every second.

Door, boot or bonnet

Triggering of the alarm

This is indicated by sounding of the siren

and ﬂashing of the direction indicators for 30

seconds.

Depending on the country of sale, certain

monitoring functions remain active until the alarm

has been triggered eleven times consecutively.

When the vehicle is unlocked using the remote

control or the Keyless Entry and Start system,

rapid ﬂashing of the red indicator lamp in the

button informs you that the alarm was triggered

If an opening is not properly closed,

the vehicle is not locked, but the exterior

perimeter monitoring will be activated after

45 seconds, at the same time as the interior

volumetric and anti-tilt monitoring.

Deactivating the interior volumetric

and anti-tilt monitoring

► Switch oﬀ the ignition and within 10 seconds

press the alarm button until its red indicator lamp

is on ﬁxed.

Deactivation

► Press the remote control unlocking

button.

► Get out of the vehicle.

► Unlock the vehicle by pressing the driver’s

door handle.

► Immediately lock the vehicle using the remote

control or the Keyless Entry and Start system.

CarManuals2.com

Access

during your absence. When the ignition is

switched on, this ﬂashing stops.

Window controls remain operational for

approximately 45 seconds after switching

oﬀ the ignition or after locking the vehicle.

After that time, the controls are disabled.

To reactivate them, switch on the ignition or

unlock the vehicle.

Electric windows

Failure of the remote control

To deactivate the monitoring functions:

► Unlock the vehicle using the key in the

driver's door lock.

Anti-pinch

► Open the door; the alarm is triggered.

► Switch on the ignition; this stops the alarm.

The indicator lamp in the button goes oﬀ.

1. Left-hand front

2. Right-hand front

3. Right-hand rear

If the window meets an obstacle while rising, it

stops and immediately partially lowers again.

4. Left-hand rear

5. Deactivation of electric window controls

located by rear seats

Overtaking of the anti-pinch

After triggering the anti-pinch, check

that there are no obstacles blocking the

movement of the window.

Locking the vehicle without

activating the alarm

► Lock or deadlock the vehicle using the key

(built-in the remote control) in the driver's door

lock.

For more information on the Electric child lock,

refer to the corresponding section.

Try to close the window again.

If the window closing is interrupted by the

anti-pinch 3 times in a row (max. 10 seconds

between each action), the anti-pinch function

becomes inoperable.

Without this protection, the window can only

be closed manually - risk of injury!

Manual operation

Malfunction

When the ignition is switched on, the ﬁxed

lighting of the red indicator lamp in the button

indicates a system malfunction.

Have it checked by a PEUGEOT dealer or a

qualiﬁed workshop.

► To open/close the window, press/pull the

switch without passing the point of resistance;

the window stops as soon as the switch is

released.

Automatic operation

Deactivating the rear

controls for the rear electric

windows

► To open/close the window, press/pull the

switch past its resistance point: the window

opens/closes completely when the switch is

released.

Automatic activation

(Depending on version)

The system is activated automatically 2 minutes

after the last door or the boot is closed.

► To avoid triggering the alarm on entering the

vehicle, ﬁrst press the unlocking button on the

remote control or unlock the vehicle using the

"Keyless Entry and Start" system.

Operating the switch again stops the movement

of the window.

CarManuals2.com

Access -> Alarm for Your Peugeot 3008 SUV Third Generation (2024-2025)

Related Topics

Access