2024-2025 Peugeot 3008 SUV Access -> Back-up procedures User Manual

MY CAR USER MANUAL

Access -> Back-up procedures for Your Peugeot 3008 SUV Third Generation (2024-2025)

Access  
Automatic (anti-intrusion  
security)  
The doors and boot lock automatically while  
driving (speed above 6 mph (10 km/h)).  
To deactivate/reactivate this function (activated  
by default):  
Complete unlocking/locking Central locking not  
2
of the vehicle with the key  
functioning  
Use this procedure in the following situations:  
– Remote control battery discharged.  
– Remote control malfunction.  
– Vehicle battery discharged.  
– Vehicle in an area subject to strong  
electromagnetic interference.  
In the first case, change the remote control  
battery.  
Use these procedures in the following cases:  
– Central locking malfunction.  
– Battery disconnected or discharged.  
In the event of a malfunction of the  
central locking system, the battery must  
be disconnected to ensure that the vehicle is  
locked fully.  
► Press the button until a confirmation  
message appears.  
Transporting long or voluminous  
objects  
In the second case, reinitialise the remote  
control.  
Refer to the corresponding sections.  
Press the central locking control to drive  
with the boot open and the doors locked.  
Otherwise, every time the speed of the  
vehicle exceeds 6 mph (10 km/h), the sound  
of the locks rebounding will be heard and an  
alert will be displayed.  
Driver's or front left-hand door  
(depending on version)  
► Insert the key into the door lock.  
► Turn the key towards the rear of the vehicle  
to lock it, or towards the front to unlock it.  
Other doors  
Unlocking  
Back-up procedures  
► Insert the key into the door lock.  
► Turn the key towards the front/rear to unlock/  
lock the vehicle.  
► Turn the key towards the rear again within  
3 seconds to deadlock the vehicle.  
► Pull the interior door opening control.  
Lost keys, remote control,  
electronic key  
Go to a PEUGEOT dealer with the vehicle's  
registration certificate, your personal  
identification documents and if possible, the label  
bearing the key code.  
If the vehicle is fitted with an alarm, it will  
not be activated when locking with the  
key.  
If the alarm is activated, the siren sounds  
when the door is opened; switch on the  
ignition to stop it.  
The PEUGEOT dealer will be able to retrieve the  
key code and the transponder code, enabling a  
new key to be ordered.  
35  
CarManuals2.com  
Access  
Locking  
Battery type: CR2032/3 volts.  
located in the corner, then clip the cover onto  
the unit.  
► Reinitialise the remote control.  
For more information on Reinitialising the  
remote control, refer to the corresponding  
section.  
Without Keyless Entry and Start  
Do not throw remote control batteries  
away, as they contain metals that are  
harmful to the environment. Take them to an  
approved disposal point.  
This equipment contains a button type  
battery.  
Do not swallow the battery. Risk of chemical  
burns!  
Swallowing the battery can cause serious  
internal burning in only 2 hours and can be  
fatal.  
If batteries have been swallowed or inserted  
into a part of the body, seek immediate  
medical advice.  
Keep new and used batteries out of the reach  
of children.  
If the battery compartment does not close  
properly, stop using the product and keep it  
out of the reach of children.  
► Open the doors.  
► For the rear doors, check that the child lock  
is not on.  
Refer to the corresponding section.  
► Remove the black cap, located on the edge  
of the door, using the key.  
► Insert the key into the socket without forcing  
it, then turn the latch towards the inside of the  
door.  
With Keyless Entry and Start  
► Remove the key and refit the black cap.  
► Close the doors and check from the outside  
that the vehicle is locked.  
Changing the battery  
If the battery is flat, this warning lamp  
comes on, accompanied by an audible  
signal and the display of a message.  
► Unclip the cover by inserting a small  
screwdriver in the slot and lift the cover.  
► Remove the flat battery from its housing.  
► Put the new battery in place, respecting the  
polarity. Start by inserting it into the contacts  
Risk of explosion if the battery is  
replaced with an incorrect type!  
Replace the battery with the same type.  
36  
CarManuals2.com  
Access  
If the fault persists after reinitialisation, contact  
a PEUGEOT dealer or a qualified workshop  
without delay.  
Risk of explosion or leaking of  
inflammable liquid or gas!  
Do not use in/store in/place in an environment  
where the temperature is extremely high or  
where the pressure is extremely low due to  
very high altitude.  
► Switch off the ignition and remove the key  
from the ignition switch.  
The remote control is now fully operational  
again.  
2
Doors  
With Keyless Entry and Start  
Do not try to burn, crush or cut a used battery.  
Opening  
Reinitialising the remote  
control  
Following replacement of the battery or in  
the event of a fault, it may be necessary to  
reinitialise the remote control.  
From outside  
► After unlocking the vehicle or with the  
"Keyless Entry and Start" system electronic key  
in the recognition zone, pull the door handle.  
From inside  
Without Keyless Entry and Start  
► Pull the interior opening control of a door; this  
unlocks the vehicle completely.  
With selective unlocking activated:  
– Opening the driver's door unlocks  
the driver's door only (if the vehicle has not  
already been completely unlocked).  
– Opening one of the passenger doors  
unlocks the rest of the vehicle.  
► Insert the mechanical key (incorporated into  
the remote control) into the lock to open the  
vehicle.  
► Place the electronic key against the back-up  
reader on the steering column and hold it there  
until the ignition is switched on.  
► With a manual gearbox, place the gear lever  
in neutral then fully depress the clutch pedal.  
► With an automatic gearbox or drive  
selector, while in mode P, depress the brake  
pedal.  
Closing  
If a door is not properly closed, this  
warning lamp comes on accompanied by  
a message if the engine is running, and an  
audible signal when the vehicle is travelling at  
more than 6 mph (10 km/h).  
► Switch the ignition off.  
► Turn the key to position 2 (Ignition on).  
► Immediately press the closed padlock button  
for a few seconds.  
► Switch on the ignition by pressing the  
"START/STOP" button.  
37  
CarManuals2.com  

Related Topics

Access

Remote control and Key
Central locking
Doors
Boot
Alarm
Electric windows
Sunroof