Lighting and visibility
Headlamp dipping
Exterior lighting control
stalk
4
Main lighting
► Rotate the ring forwards/backwards to turn
it on/off.
When the lighting is switched off automatically
("AUTO" position) the foglamp and the
sidelamps remain on.
► Pull the lighting control stalk to switch
between dipped and main beam headlamps.
In lamps off or "AUTO" modes, depending on
version, and in sidelamps mode, pull the lighting
control stalk to switch the main beam headlamps
on directly ("headlamp flash").
Switching on the foglamps is prohibited
in clear weather or in rain, both day and
night. In these situations, the power of their
beams may dazzle other drivers. They must
only be used in fog or falling snow (rules may
vary depending on country).
Automatic illumination of lamps/daytime
running lamps
or
Do not forget to switch off the foglamps when
they are no longer necessary.
Display
Lamps off (ignition off)/
Daytime running lamps (engine running)
Sidelamps only
Illumination of the corresponding indicator
lamp on the instrument panel confirms that the
selected lighting is on.
A fault with a lamp is signalled by the
permanent illumination of this warning
lamp, accompanied by the display of a message
and an audible signal.
Switching off of the lighting when the
ignition is switched off
When the ignition is switched off, all of the
lamps turn off immediately, except for the
dipped beam headlamps if automatic guide-
me-home lighting is activated.
Dipped or main beam headlamps
"Highway function"
(Depending on country of sale)
With "Full LED" technology headlamps, the
range of the dipped beam headlamps is
automatically increased once the speed of the
vehicle is above 68 mph (110 km/h).
Rear foglamp
Switching on the lamps after
switching off the ignition
To reactivate the lighting control, rotate the
ring, depending on version, to the "0" position
- lamps off, or to the "AUTO" position, then to
the desired position.
It only works if the dipped or main beam
headlamps are on.
59
