Practical information -> Bonnet for Your Peugeot 3008 SUV Third Generation (2024-2025)

Practical information  
Before carrying out any work under the  
Selecting the mode  
A confirmation message is displayed when  
energy economy mode is entered, and the active  
functions are placed on standby.  
Load reduction mode  
This system manages the use of certain  
functions according to the level of charge  
remaining in the battery.  
bonnet, you must switch off the ignition, check  
that the READY indicator lamp is off on the  
instrument panel and disconnect the nozzle  
from the charging connector if it is connected.  
When the vehicle is being driven, the load  
reduction function temporarily deactivates certain  
functions, such as the air conditioning and the  
heated rear screen.  
If a telephone call is in progress at the  
time, it will be maintained for around 10  
minutes via the audio system’s hands-free  
system.  
The deactivated functions are reactivated  
automatically as soon as conditions permit.  
Exiting the mode  
The location of the interior bonnet  
release lever prevents the bonnet being  
opened when the left-hand front door is  
closed.  
These functions are automatically reactivated the  
next time the vehicle is used.  
Bonnet  
To restore the use of these functions  
Stop & Start  
immediately, start the engine and let it run:  
– For less than 10 minutes, to use the  
equipment for approximately 5 minutes.  
– For more than 10 minutes, to use the  
equipment for approximately 30 minutes.  
Let the engine run for the specified duration to  
ensure that the battery charge is sufficient.  
To recharge the battery, avoid repeatedly or  
continuously restarting the engine.  
Before doing anything under the bonnet,  
you must switch off the ignition to avoid any  
risk of the engine restarting automatically.  
Take care with objects or clothing that could  
be caught in the blades of the cooling fan  
or in certain moving components - risk of  
strangulation and serious injury!  
When the engine is hot, handle the  
exterior safety catch and the bonnet stay  
with care (risk of burns), using the protected  
area.  
When the bonnet is open, take care not to  
damage the safety catch.  
Do not open the bonnet under very windy  
conditions.  
A flat battery prevents the engine from  
starting.  
For more information on the 12 V battery,  
refer to the corresponding section.  
Cooling of the engine when stopped  
The engine cooling fan may start after  
the engine has been switched off.  
Take care with objects or clothing that  
could be caught in the blades of the fan!  
Electric motor  
Take care with objects or clothing that  
could be caught in the blades of the cooling  
fan or in certain moving components - risk of  
strangulation and serious injury!  
164  
Practical information  
Diesel engine  
Opening  
► Open the left-hand front door.  
Closing  
7
► Hold the bonnet and pull out the stay from the  
support slot.  
► Clip the stay in its housing.  
► Lower the bonnet and release it near the end  
of its travel.  
► Pull on the bonnet to check that it is locked  
correctly.  
1. Screenwash fluid reservoir  
2. Engine coolant reservoir  
3. Brake fluid reservoir  
4. Battery/Fuses  
5. Fusebox  
6. Air filter  
Because of the presence of electrical  
equipment under the bonnet, it is strongly  
recommended that exposure to water (rain,  
washing, etc.) be limited.  
► Pull the interior release lever, located at the  
bottom of the door frame, towards you.  
7. Engine oil filler cap  
8. Engine oil dipstick  
Engine compartment  
The engine shown here is an example for  
illustrative purposes only.  
The locations of the following components may  
vary:  
Diesel fuel system  
This system is under very high pressure.  
All work must be carried out only by a  
PEUGEOT dealer or a qualified workshop.  
– Air filter.  
– Engine oil dipstick.  
– Engine oil filler cap.  
Electric motor  
Petrol engine  
► Lift the exterior safety catch and raise the  
bonnet.  
► Unclip the stay from its housing and place it  
in the support slot to hold the bonnet open.  
1. Screenwash fluid reservoir  
2. Engine coolant reservoir (level only)  
165