Driving -> Blind spot warning for Your Renault Kadjar SUV 2020

BLIND SPOT WARNING (1/4)  
1
A
A
This system alerts the driver to other  
vehicles in the detection zone A.  
Special feature  
Make sure that the sensors are not ob-  
scured (by dirt, mud, snow, etc.).  
If a sensor is obscured, the message  
“Blind spotclean sensor” will appear on  
the instrument panel. Clean the sen-  
sors.  
The system is activated when the vehi-  
cle’s speed is between approximately  
30 km/h (19 mph) and 140 km/h (87  
mph).  
This function uses sensors 1 installed  
in the front and rear bumper of both  
sides.  
This function is an addi-  
tional aid which indicates  
other vehicles in the blind  
spot area.  
It can never in any case be a subs-  
titute for care nor for the driver’s  
responsibility while in charge of his  
vehicle.  
2.47  
BLIND SPOT WARNING (2/4)  
– repeatedly press control 5 up or  
down until you reach the “Blind spot  
alert” menu, then press the switch 4  
OK.  
3
– Press the switch 4 OK again to acti-  
vate or deactivate the function.  
4
5
2
Vehicles not fitted with a navigation  
system  
Activation/deactivation  
Vehicles fitted with a navigation  
system  
– With the vehicle at a standstill, press  
and hold the switch 4 OK to access  
the settings menu;  
From the multimedia screen 3, select  
the “Vehicle” menu, “Driving assist-  
ance”, “Blind spot alert” then choose  
“ON” or “OFF”.  
– repeatedly press the control 5 up or  
down until you reach the “Driving as-  
sistance” menu. Press the switch 4  
OK;  
You can access menu “Driving as-  
sistance” directly from button 2  
Whentheengineisstarted,thesystem  
remembersitspositionwhentheigni-  
tion was last switched off.  
.
2.48  
BLIND SPOT WARNING (3/4)  
Display B  
The function is activated and has not  
detected any vehicles.  
4
4
B
C
Display C  
Initial warning: the indicator light 4  
shows that a vehicle has been detected  
in the blind spot.  
5
Display D  
D
When the direction indicator is acti-  
vated, the indicator light 4 flashes when  
a vehicle is detected in the blind spot on  
the side towards which you are about to  
steer. If you cancel the direction indica-  
tor, the function will return to the initial  
warning (display C).  
Indicator 4  
An indicator light 4 is located on each  
door mirror 5.  
Operation  
This function will indicate:  
– when the vehicle speed is between  
approximately 30 km/h (19 mph) and  
140 km/h (87 mph);  
– when another vehicle is in the blind  
spot area and travelling in the same  
direction as your vehicle.  
Note: Clean the door mirrors 5 regu-  
larly, so that the indicator lights 4 can  
be seen properly.  
If another vehicle is being overtaken,  
the indicator 4 will be activated only if  
that vehicle remains in the blind spot for  
more than one second.  
Note: The system’s detection range  
operates according to a standard  
lane width. If you are driving in  
narrow traffic lanes, it may detect  
vehicles in other lanes.  
2.49  
BLIND SPOT WARNING (4/4)  
Operating faults  
4
If the system detects a fault, the mes-  
sage “Check blind spot alert” is dis-  
played on the instrument panel. Consult  
an authorised dealer.  
B
Note: When the engine is started, the  
indicator light 4 (display B) flashes  
three times. It is normal.  
C
D
– The system’s detection  
range operates according  
to a standard lane width. If  
you are driving in wide traf-  
fic lanes, the system might not  
be able to detect a vehicle in the  
blind spot.  
Conditions for non-function  
– If the object is not moving;  
– if traffic is heavy;  
– the road is winding;  
– if front and rear sensors both detect  
objects at the same time (e.g. when  
passing an articulated lorry).  
– The system might be disrupted  
momentarily if it is exposed to  
strong electromagnetic waves  
(as beneath high-tension power  
lines) or to very poor weather  
conditions (heavy rain, snow,  
etc.). Remain aware of driving  
conditions.  
– ...  
Because sensors have  
been installed in the bump-  
ers, any work (repairs, re-  
placements, touching up of  
paintwork) must be carried out by a  
qualified professional.  
There is a risk of accidents.  
2.50