Driving -> Electronic parking brake for Your Renault Kadjar SUV 2020

ELECTRONIC PARKING BRAKE (1/4)  
In all other circumstances, for example,  
stalled engine or engine switched to  
standby by the Stop and Start func-  
tion (refer to the information on the  
“Stop and Start function” in Section 2),  
the electronic parking brake is not ap-  
plied automatically. Manual mode must  
be used.  
1
4
For certain country-specific model ver-  
sions, the assisted brake application  
function is not activated. Refer to the  
information on “Manual operation”.  
3
2
To confirm that the electronic parking  
brake is applied, the message “Parking  
brake on” and warning light  
on the instrument panel and warning  
light 4 on the switch 3 light up.  
After the engine is switched off, indi-  
cator light 4 goes out several minutes  
after the assisted parking brake has  
}
or  
Assisted operation  
– for vehicles fitted with an automatic  
gearbox, when position P is en-  
gaged;  
Applying the electronic parking  
brake  
or  
With the vehicle stationary, the elec-  
tronic parking brake can be used to im-  
mobilise the vehicle:  
by pressing the engine start/stop  
button 1 or by turning the ignition  
key 2 (to the “ON” position 2);  
or  
– when the driver leaves the seat  
base of their seat (e.g.: to bend  
over to collect an object on the rear  
floor, etc.).  
been applied and indicator light  
goes out when the vehicle is locked.  
}
– when the driver’s seat belt is un-  
fastened;  
or  
Before leaving the vehicle, check that the electronic parking brake is fully  
applied. Warning light 4 on switch 3 and warning light on the  
instrument panel light up to show that the parking brake is applied but go  
out when the doors are locked.  
– when the driver’s door is opened;  
2.16  
ELECTRONIC PARKING BRAKE (2/4)  
Assisted operation  
(continued)  
Note: in some situations (electronic  
parking brake failure, manual release of  
the parking brake, etc.), a beep sounds  
and the message “Apply parking brake”  
appears on the instrument panel to  
warn you that the electronic parking  
brake has been released.  
1
4
3
– with the engine running: when the  
driver’s door is opened;  
– with the engine switched off (e.g.  
when the engine stalls): when a front  
door is opened.  
2
In this case, pull and release switch 3 to  
apply the assisted parking brake.  
Manually releasing the electronic  
parking brake  
Press switch 1 without pressing the  
pedals or turning the key 2 to position  
“ON” 2 to switch on the ignition. Press  
the brake pedal then press switch 3: in-  
dicator light 4 on the switch and indica-  
Manual operation  
You can apply the electronic parking  
brake manually.  
Assisted release of the parking  
brake  
The brake will be released as soon as  
the vehicle starts and accelerates.  
Manually applying the electronic  
parking brake  
Pull switch 3. Warning light 4 and warn-  
tor light  
ment panel go out.  
}
displayed on the instru-  
ing light  
light up.  
}
on the instrument panel  
Before leaving the vehicle, check that the electronic parking brake is fully applied. Warning light 4 on switch 3 and  
warning light on the instrument panel light up to show that the parking brake is applied but go out when the  
}
doors are locked.  
2.17  
ELECTRONIC PARKING BRAKE (3/4)  
1
4
3
2
– with the engine running, while si-  
multaneously depressing the brake  
pedal and the switch 3, stop the  
engine (not standby for vehicles  
fitted with Stop and Start);  
– with a gear or position P engaged,  
release the brake pedal and the  
switch 3.  
Brief stop  
To apply the electronic parking brake  
manually (when stopping at a red light,  
or stopping when the engine is running,  
etc.): pull and release the switch 3. The  
brake is released as soon as the vehi-  
cle is started up again.  
Special feature related to  
the Stop and Start function:  
if the driver's seat is unfas-  
tened before the engine  
goes into standby due to the Stop  
and Start function, make sure that  
the parking brake is applied: the  
For vehicles fitted with the Stop and  
Start function, with the engine on  
standby, the electronic parking brake  
is automatically activated if the driver  
unfastens their seat belt and opens the  
driver's door or gets out of their seat.  
Special cases  
To park on a slope or while towing a  
trailer, for example, pull switch 3 for  
a few seconds to gain the maximum  
braking.  
Risk of loss of immobilisation.  
indicator light on the instru-  
ment panel confirms this.  
To park the vehicle without applying the  
electronic parking brake (if there is a  
risk of freezing, for example):  
2.18  
ELECTRONIC PARKING BRAKE (4/4)  
Versions with an automatic  
Operating faults  
gearbox  
– If there is a fault, the © warning  
light illuminates on the instrument  
panel accompanied by the “Check  
parking brake” message and, in  
For safety reasons, automatic release  
is deactivated when the driver’s door  
is open or not shut properly and the  
engine is running (in order to prevent  
the vehicle from moving without the  
driver). The “Release parking brake  
manually” message appears on the  
instrument panel when the driver de-  
presses the accelerator.  
In the event of message  
“Electric failure DANGER”  
or “Check battery”, manu-  
ally activate the electronic  
parking brake by pulling switch 4 (or  
position the gear lever in P for au-  
tomatic gearboxes) before stopping  
the engine.  
some cases, the  
light.  
Contact your approved Dealer  
straight away.  
warning  
– If there is an assisted parking brake  
fault, the warning light ® comes  
on, along with the message “Braking  
system fault”, a beep and, in some  
Risk of loss of immobilisation of  
the vehicle.  
cases, the warning light  
.
Call an approved Dealer.  
This means that you must stop as  
soon as traffic conditions allow.  
If no lights or sounds are ap-  
parent, this indicates a fault  
in the instrument panel. This  
Never leave your vehicle  
without moving the selector  
lever to position P. This is  
because when the vehicle  
is stationary with the engine running  
and a gear engaged, the vehicle  
may begin to move if you acceler-  
ate.  
It is therefore essential to  
immobilise the vehicle by  
engaging first gear (manual  
gearbox) or position P (au-  
tomatic gearbox). If the slope re-  
quires it, chock the vehicle.  
indicates that it is essential  
to stop immediately (as soon as traf-  
fic conditions allow). Ensure that the  
vehicle is correctly immobilised and  
contact an approved Dealer.  
There is a risk of accidents.  
2.19