Get Driving -> Lane departure warning Guide for Renault Kadjar SUV 2020

LANE DEPARTURE WARNING (1/3)

This system notifies the driver when

they accidentally cross a continuous or

broken line.

This function uses a camera attached

to the windscreen, behind the rear-view

mirror.

This function is a driving aid in the event of the accidental crossing of

a continuous or broken line in the road. However, the function is not in-

tended to replace the driver. The function can be disrupted under certain

conditions, including:

– poor visibility (rain, snow, fog, dirty windscreen, glare of the sun, partially ob-

scured road lines, etc.);

– roads with tight bends;

– closely following a vehicle in the same lane;

– worn road markings, difficult to distinguish or spaced very widely apart;

– narrow roads;

– ...

In this case, the line visibility indicators remain uncoloured on the instrument

panel to indicate that the function will not operate (lines not detected).

Under no circumstances should this function replace the driver’s care or respon-

sibility whilst performing manoeuvres.

2.44

LANE DEPARTURE WARNING (2/3)

Vehicles not fitted with a navigation

system

The function is set to notify the

driver if:

– the vehicle speed is greater than ap-

proximately 45 mph (70 km/h);

and

– lines are detected and the visibility

indicators 4 are green.

Activation/deactivation

Vehicles fitted with a navigation

system

Press the switch 3.

From the multimedia screen2: select

“Vehicle”, “Driving assistance”, “Lane

departure warning check” then choose

“ON” or “OFF”.

Operation

With the function activated, the grey

visibility indicators 4 for the left and

right lines are displayed on the instru-

ment panel.

The function triggers an alert if a line

is crossed without the direction indica-

tors being activated. The function alerts

the driver through a beep and the indi-

cator the line crossed switches to red

on the instrument panel.

You can access menu “Driving as-

sistance” directly from button 1



2.45

LANE DEPARTURE WARNING (3/3)

Adjustment

– repeatedly press control 6 up or

down until you reach the “Lane de-

parture warning settings” menu, then

press the switch 5 OK.

Vehicles fitted with a navigation

system

– Volume: adjust the alert volume to

one of three levels;

– sensitivity: adjust the sensitivity level

for line detection. To do this select:

– “Low” line detected upon cross-

ing;

– “Average” line detected on ap-

proach;

– “high” line detected nearby.

From the multimedia screen 2, select

“Vehicle”, “Driving assistance”, then

“Lane departure warning settings”.

– Volume: adjust the alert volume to

one of five levels;

– sensitivity: adjust the sensitivity level

for line detection. To do this, select:

– “Low” line detected upon cross-

ing;

– “Average” line detected on ap-

proach;

– “high” line detected nearby.

Operating faults

In the event of a malfunction, a mes-

sage “Lane departure warning check” is

displayed on the instrument panel, and

the visibility indicators for the left and

right lines disappear from the instru-

ment panel.

Conditions for non-activation

of alerts

– Direction indicators activated less

than around two seconds before de-

parting from the lane;

– very fast lane departure;

– driving continuously on a line;

– on bends, the function allows for

slightly cutting the bend;

– hazard warning lights activated;

– ...

Vehicles not fitted with a navigation

system

– With the vehicle at a standstill, press

and hold the switch 5 OK to access

the settings menu;

– repeatedly press the control 6 up or

down until you reach the “Driving as-

sistance” menu. Press the switch 5

OK;

Consult an approved dealer.

2.46

Driving -> Lane departure warning for Your Renault Kadjar SUV 2020

Popular Manuals