Get Driving -> Parking distance control Guide for Renault Kadjar SUV 2020

PARKING DISTANCE CONTROL (1/5)

Operating principle

Ultrasonic sensors in the rear bumper

measure the distance between the ve-

hicle and an obstacle.

This measurement is indicated by

beeps which become more frequent the

closer you come to the obstacle, until

they become a continuous beep when

the vehicle is approximately 20 to

30 centimetres from the obstacle.

This function is an addi-

tional aid that indicates the

distance between the vehi-

cle and an obstacle whilst

reversing, using sound signals.

The system detects obstacles to the

front, the rear and the sides of the ve-

hicle.

The parking distance control system

is only activated when the vehicle is

driven at a speed below approximately

6 mph (10 km/h).

Under no circumstances should it

replace the driver’s care or respon-

sibility whilst reversing.

Special features

Ensure that the ultrasonic sensors indi-

cated by arrows 1 are not obscured (by

dirt, mud, snow, etc.).

The driver should always be ready

for sudden incidents while driv-

ing: always ensure that there are

no small, narrow moving obstacles

(such as a child, animal, pushchair,

bicycle, stone, post, etc.) in the blind

spot when manoeuvring.

The parking distance control system

does not take into account towing and

load carrying systems etc.

2.61

PARKING DISTANCE CONTROL (2/5)

Note: the display 2 shows the vehicle

surroundings and emits beeps.

Operation

Most objects located less near the

front, rear and sides of the vehicle are

detected.

It is necessary to travel a few metres

before the side detection is activated.

If all areas have a grey background, the

whole area around the vehicle is being

monitored:

Depending on the distance of the ob-

stacle, the frequency of the beep will

be higher while approaching it, and

will become a continuous beep around

20 cm away for obstacles to the sides,

and around 30 cm for obstacles to the

front or rear. Green, orange and red

zones will be displayed on the dis-

play C.

– A: analysis of the vehicle surround-

ings in progress;

– B: analysis of the vehicle surround-

ings carried out

2.62

PARKING DISTANCE CONTROL (3/5)

If a side obstacle is detected:

– the beeps become faster and then

sound continuously as the obstacle

gets nearer. Green, orange and red

zones will be displayed on the dis-

play D;

– if there is no risk of collision, no beep

will sound when approaching the ob-

stacle. Green, orange and red zones

will be displayed interspersed on the

display D.

Note: in the event of a change in tra-

jectory during a manoeuvre, the risk of

collision with an obstacle may be sig-

nalled late.

Detection of obstacles to the side

Depending on the direction of the

wheels, the system determines the tra-

jectory of the vehicle and notifies the

driver of any risk or otherwise of a col-

lision with an obstacle 3 to the side of

the vehicle.

An impact to the under-

side of the vehicle while

manoeuvring (e.g. strik-

ing a post, raised kerb or

other street furniture) may result in

damage to the vehicle (e.g. defor-

mation of an axle).

To avoid any risk of accident, have

your vehicle checked by an ap-

proved Dealer.

2.63

PARKING DISTANCE CONTROL (4/5)

System sound

Enables the system sound to be se-

lected from a choice of 3.

Deactivating the system sound

Activate or deactivate the parking dis-

tance control sound.

Note: If you deactivate the sound, you

will no longer be notified with beeps

when approaching an obstacle.

Deactivating the system

Activate or deactivate parking distance

control.

Vehicles not fitted with a navigation

system

– press the switch 5 OK;

– using the control 6, select the set-

tings to be changed;

Adjustment

Vehicle stationary:

– press and hold the switch 5 OK to

access the settings menu;

– repeatedly press the control 6 up or

down until you reach the “Driving as-

sistance” menu;

You can adjust certain settings from the

multifunction screen 4. Please see the

equipment instructions for further infor-

mation.

– press the switch 5 OK.

Vehicles fitted with a navigation

system

– press the switch 5 OK;

– repeatedly press the control 6 up or

down until you reach the “Parking

distance control settings” menu;

Select “Vehicle”, “PARKING ASSIST”,

“Obstacle detection”.

Parking distance control audio

volume

When the vehicle is being driven at

a speed below approximately 6 mph

(10 km/h), certain noises (motorcy-

cle, lorry, pneumatic drill, etc.) may

trigger the beeping sound of the

parking distance control.

Adjust the volume of the parking dis-

tance control by pressing + or -.

2.64

PARKING DISTANCE CONTROL (5/5)

Automatic deactivation of the

parking distance control

The system deactivates:

Operating faults

When the system detects an operating

fault, a beep sounds for approximately

3 seconds each time reverse gear is se-

lected and is accompanied by the mes-

sage “Check parking sensor” shown on

the instrument panel. Consult an ap-

proved dealer.

– when the vehicle speed is above ap-

proximately 6 mph (10 km/h);

– depending on the model, when the

vehicle is stationary for more than

approximately 5 seconds and an ob-

stacle is detected (such as when in a

traffic jam, etc.);

– when the vehicle is in neutral for

manual gearboxes, or in position N

or P for automatic gearboxes.

2.65

Driving -> Parking distance control for Your Renault Kadjar SUV 2020

Popular Manuals