TYRE PRESSURE KIT (3/3)
– Start immediately and drive at be-
tween 12 and 37 mph (20 and
60 km/h) in order to distribute the
product evenly in the tyre; after driv-
ing a distance of 2 miles (3 km), stop
and check the pressure.
3
Please be aware that a
poorly tightened or miss-
ing valve cap can make the
tyres less airtight and may
– If the pressure is higher than 1.3 bar
but lower than the recommended
pressure (refer to the label affixed to
the edge of the driver’s door), adjust
it. Otherwise, contact an approved
dealer: the tyre cannot be repaired.
lead to pressure loss.
Always use valve caps identical to
those fitted originally and tighten
them fully.
Precautions when using the
kit
The kit should not be operated for more
than 10 consecutive minutes.
Once the tyre is correctly inflated,
remove the kit: slowly unscrew the in-
flation end piece 3 to prevent any prod-
uct spatter and store the container in
plastic packaging to prevent product
leaks.
The container must be replaced after
the first use even if liquid remains
inside.
Following repair with the kit,
do not travel further than
120 miles (200 km). In addi-
tion, reduce your speed and
– Affix the driving recommendation
label to the dashboard where it can
easily be seen by the driver;
under no circumstances exceed
48 mph (80 km/h). The sticker,
which you must affix in a prominent
position on the dashboard, reminds
you of this.
Depending on the country or local
legislation, a tyre repaired with the
inflation kit may need to be replaced.
– Put the kit away;
– At the end of this initial inflation op-
eration, air will still escape from the
tyre. You must drive a short distance
in order to seal the hole;
5.6