Engine, exhaust system and fuel -> Coolant for Your Skoda Kodiaq SUV 2020

196 Engine, exhaust system and fuel › Coolant  
Read the oil level and push the dipstick back in  
again.  
flashes, lights up at the same time  
Check the engine oil level.  
The oil level is OK, the warning light continues to  
flash:  
Stop the engine and seek the help of a specialist  
garage.  
Engine oil level too low  
illuminates together with  
or  
The oil level must be within the marked range.  
illuminates together with  
Message regarding required engine oil top up  
NOTICE  
Risk of damage to the engine and the exhaust sys-  
tem!  
Check the engine oil level, top up with oil if re-  
quired.  
The oil level must not be outside the marked range.  
If it is not possible to top up the engine oil or if the  
oil level is above the marked range, do not continue  
driving. Stop the engine and seek the help of a spe-  
cialist garage.  
Engine oil level too high  
illuminates together with  
or  
Do not use any oil additives.  
illuminates together with  
Message regarding the need to reduce the  
engine oil level  
Consumption  
Depending on driving style and operating conditions,  
the engine consumes some oil, up to 0.5 l/1000 km.  
Consumption may be higher over the next 5000 km.  
Check the engine oil level.  
The oil level is too high:  
Refilling  
Drive on, exercising appropriate caution.  
Seek the help of a specialist garage.  
Unscrew the cover of the engine oil filler opening.  
Top up the oil to the correct specification in 0.5 li-  
tre portions.  
Check the oil level.  
Engine oil level sensor impaired  
illuminates together with  
Screw on the cover of the engine oil filler opening.  
or  
Specification  
Ask a specialist garage for the correct engine oil  
specification for your vehicle.  
illuminates together with  
Message regarding the engine oil sensor  
If no oil of the correct specification is available, max.  
0.5 l of oil with the following specifications may be  
used until the next oil change.  
Drive on, exercising appropriate caution.  
Seek the help of a specialist garage.  
Petrol engines: VW 504 00, VW 508 00,  
ACEA C3, ACEA C5.  
Coolant  
Diesel engines: VW 507 00, VW 509 00, ACEA C3  
or API CJ-4. For vehicles without a particulate fil-  
ter, VW 505 01 can be optionally used.  
Coolant temperature display  
Changing  
Have the oil changed by a specialist garage.  
Troubleshooting  
Engine oil pressure too low  
flashes, lights up at the same time  
or  
A
Cold area  
Engine, exhaust system and fuel › Coolant 197  
Troubleshooting  
Avoid high engine speeds.  
B
Operating range  
Coolant level is too low  
C
High temperature range  
illuminates together with  
or  
Checking the fill level and topping up  
illuminates together with  
Message concerning the required coolant  
check  
Test conditions  
The vehicle is on a horizontal surface.  
The engine is turned off and cooled.  
Check the coolant level.  
Checking the level  
The coolant level is OK:  
The fill level must be  
within the marked range.  
Check the fuse for radiator fan, replace if re-  
quired » page 205, Replacing a fuse.  
If the fill level is below  
The fuse is OK, the indicator light comes on again:  
the mark  
, top up  
Stop driving! Seek the help of a specialist garage.  
the coolant.  
Coolant temperature too high  
illuminates together with  
or  
illuminates together with  
Report regarding the engine overheating  
NOTICE  
Danger of damage to the engine compartment!  
Stop driving.  
Stop the engine and allow it to cool.  
Drive on after the indicator light goes out.  
Do not top up the coolant above the marked area.  
The coolant could be forced out of the cooling sys-  
tem when heated.  
NOTICE  
Engine fault  
There must be a small quantity of coolant in the tank.  
Do not add coolant when the tank is empty.  
illuminates together with  
Stop driving! Seek the help of a specialist garage.  
or  
Refilling  
CAUTION  
illuminates together with  
Stop driving!  
Stop the engine and seek the help of a specialist  
garage.  
Risk of scalding!  
The cooling system is pressurised.  
Do not open the cap of the coolant expansion tank  
while the engine is warm. Let the engine cool  
down.  
There is no coolant of the correct specification  
available  
Place a rag on the lid of the tank and carefully un-  
screw the lid.  
Top up with distilled or demineralised water.  
Have the correct coolant mixing ratio corrected by  
a specialist garage as soon as possible.  
Refill with coolant of the correct specification.  
Screw on the cap until it clicks into place.  
Another substance was used for topping up, other  
than distilled or demineralised water:  
Specification  
Use the G12evo (TL 774 L) additive for refilling.  
Have the coolant changed by a specialist garage.  
NOTICE  
It is not possible to top up with a sufficient amount  
of coolant  
Stop driving.  
Stop the engine and seek the help of a specialist  
Risk of damage to the cooling system and the en-  
gine!  
Adding coolant that does not conform to the correct  
specification can reduce the corrosion protection of  
the cooling system.  
garage.  
There is a loss of coolant  
Top up the coolant and seek the help of a specialist  
garage.  
198 Engine, exhaust system and fuel › Engine electronics  
If the filter is cleaned successfully, the indicator light  
Engine electronics  
goes out  
.
Troubleshooting  
If the indicator light  
does not go off within  
40 minutes, the filter was not cleaned.  
Petrol engine control faulty  
illuminates  
Driving in emergency mode is possible - a  
noticeable reduction in engine performance may oc-  
cur.  
Continue driving, exercising appropriate caution,  
and seek the help of a specialist garage.  
Procedure for vehicles with petrol engines  
Drive at a speed of at least 80 km/h at engine  
speeds between 3000-5000 rpm.  
Release the accelerator pedal and let the vehicle  
roll with the gear engaged for a few seconds.  
Repeat this procedure several times.  
Drive on carefully, get the help of a specialist com-  
pany.  
Diesel engine control faulty  
flashes  
If the filter is cleaned successfully, the indicator light  
goes out  
.
Driving in emergency mode is possible - a noticeable  
reduction in engine performance may occur.  
If the indicator light  
does not go off within  
30 minutes, the filter was not cleaned.  
Drive on carefully, get the help of a specialist com-  
pany.  
Continue driving, exercising appropriate caution,  
and seek the help of a specialist garage.  
Diesel preheating system faulty  
illuminates, or does not illuminate after the  
ignition is switched on  
Exhaust control system  
Troubleshooting  
Driving in emergency mode is possible - a noticeable  
reduction in engine performance may occur.  
Drive on carefully, get the help of a specialist com-  
pany.  
Emission control system faulty  
illuminates  
Driving in emergency mode is possible - a no-  
ticeable reduction in engine performance may occur.  
Particle filter  
Continue driving, exercising appropriate caution,  
Troubleshooting  
and seek the help of a specialist garage.  
Clogged particle filter  
illuminates together with  
Fuel filter  
Troubleshooting  
or  
illuminates together with  
Water in the diesel fuel filter  
illuminates together with  
Clean the filter.  
or  
When the indicator light is on, it must be as-  
sumed that fuel consumption will be higher, engine  
power will be reduced, and the START-STOPP func-  
tion will not be available.  
illuminates together with  
Continue driving, exercising appropriate caution,  
and seek the help of a specialist garage.  
Filter cleaning  
Radiator blinds  
Usage  
Conditions for cleaning  
The engine is warm.  
For vehicles with manual transmission, observe  
the gear recommendation shown in the display of  
the instrument cluster.  
The radiator blinds reduce polluting emissions and  
CO2 emissions and save fuel.  
Procedure for vehicles with diesel engines  
Drive at a speed of at least 60 km/h at engine  
speeds of at least 2000 rpm.