Engine, exhaust system and fuel › Bonnet 195
Current trailer posi-
tion
Target trailer posi-
tion
A
B
C
Engine, exhaust system and fuel
Bonnet
Open the engine compartment lid
Manoeuvring angle
Before opening
Tilt the knob to the
right or left to set the
trailer's target position.
›
Make sure that the wiper arms are folded against
the windscreen.
›
Keep everyone away from the engine compart-
ment.
›
Initiate reverse.
›
The setting can be corrected when reversing.
to open
Stop as soon as the trailer's target position is
›
Pull the release lever
underneath the dash
panel.
›
reached.
CAUTION
Risk of injury!
Do not reach between the steering wheel spokes
during the parking manoeuvre.
▶
Only operate the pedals and the shift / selector
lever.
▶
Align the trailer straight
Tilt the knob backwards.
Carefully reverse and drive forwards until the de-
sired position of the trailer combination is ach-
ieved.
›
›
Release the lock.
Lift the flap so that the
gas pressure springs
keep it open.
›
›
Turn off the system
Press
the button.
›
Automatic system shutdown
If the following situations occur during the manoeu-
vring process, the system is switched off automati-
cally and the brakes are applied.
Close
▶ The button
is pressed.
Pull the flap down.
Close the flap with a slight push from a distance of
about 20 cm.
›
›
The driver's door is opened.
The steering wheel is gripped.
The driving speed is too high.
The trailer veered too much.
▶
▶
▶
▶
Check that the bonnet is closed.
›
NOTICE
Do not press an open flap.
▶
Engine oil
Checking the fill level and topping up
Test conditions
✓ The vehicle is on a horizontal surface.
✓ The parked engine is warm.
Checking the level
Wait a few minutes for the engine oil to flow back
into the oil sump.
›
Remove the dipstick and wipe with a clean cloth.
Insert the dipstick as far as it will go and pull it out
again.
›
›
