Wheels › Tyre pressure 213
Replace the tire inflation hose on the valve and re-
peat the inflation procedure.
WARNING
Risk of burns!
›
The tire inflation hose and air compressor can be-
come hot when inflated.
Tyre pressure
Allow the air compressor and hose to cool down
for a few minutes.
▶
What you should be mindful of
NOTICE
Usage restrictions
Always adjust the tyre pressure to the load.
Check the pressure in all tyres at least once a
month and before each longer ride.
Check the pressure when the tyres are cold. If nec-
essary, do not reduce the elevated pressure when
the tyres are warm.
After each change in tyre pressure, save the new
values in the tyre control display.
▶
▶
Do not use the kit in the following cases.
The rim is damaged.
▶
▶
▶
▶
The outdoor temperature is below the minimum
temperature indicated in the manual of the tyre fill-
ing bottle.
Tyre punctures are greater than 4 mm.
There is damage to the tyre wall.
The expiry date stated on the tyre inflation bottle
▶
▶
▶
WARNING
Risk of an accident!
If tyre pressure loss is very quick, try to stop the
vehicle carefully without heavy steering or heavy
braking.
has expired.
▶
Self-help
Seal the tyres
Unscrew the valve cap from the damaged tyre.
Unscrew the valve core with the valve insert and
place it on a clean surface.
Shake the tyre inflation bottle back and forth with
Stickers with prescribed tire pressure values
›
›
The sticker with prescribed tyre pressures is located
on the inside of the fuel filler flap.
›
Filling pressure for
half a load
A
sealant.
Screw the inflation hose onto the tyre inflater bot-
tle. The film on the closure is pierced automatically.
Remove the plug from the inflation hose and push
it fully onto the tyre valve.
Hold the bottle with the bottom facing upwards
and fill all of the sealing agent into the tyre.
Remove the filler plug from the valve.
Screw in the valve insert.
›
Filling pressure for
environmentally
friendly operation
(slightly lower fuel
consumption and
pollutant emissions)
Filling pressure for
full loading
B
›
›
›
›
C
D
Tire diameter in in-
Inflate tyres
Fit the tyre inflation hose of the air compressor to
the tyre valve.
Secure the vehicle with the parking brake.
Start the engine.
Plug the connector into the 12 volt socket .
Turn on the air compressor.
Once a tyre pressure of 2.0-2.5 bar is reached, turn
ches
›
This information only serves as information for
the prescribed tyre pressure. This is not a list of
approved tire sizes for your vehicle. These are in
the vehicle's technical documentation, as well as
in the declaration of conformity (in the so-called
COCDocument).
›
›
›
›
›
Tyre pressure reading for the front axle tyres
E
F
off the air compressor.
Tyre pressure reading for the rear axle tyres
Observe the maximum running time of the air com-
pressor according to the directions of the repair kit
manufacturer.
Prescribed tyre pressure value for the emergen-
cy wheel
G
If an air pressure of 2.0 - 2.5 bar has not been
reached, remove the tyre inflation hose from the
›
valve.
Drive approx. 10 metres forwards or backwards to
allow the sealing agent to distribute in the tyre.
›
