Wheels › Wheel bolt cover caps 215
Tyre pressure
Wheel bolt cover caps
B
C
D
E
Recommended tyre pressure
Tyre pressure not available
Tyre pressure too low
Pull off and install cover caps
Setting the vehicle's load condition
The tyres warm up while driving and there is an
increase in pressure. This is completely normal, it is
not a defect. If the system shows an increase in
pressure while driving, do not reduce the pressure.
Settings
Pull off
Tyre type
Push the pull-off clamp onto the cover cap up to
›
Select the tyre type in the following menu.
the stop.
Pull off the cover cap.
›
Or:
Install
Push the cover cap onto the wheel bolt to the stop.
›
Vehicle loading condition
In the following menu, select the menu item for
displaying the vehicle condition.
›
Full wheel frame
Pull off panel and install
Applies to factory installed covers or covers deliv-
ered with ŠKODA original accessories.
Or:
Remove
Using the functional surfaces
Pressure Monitoring menu item.
choose the Tyre
›
›
Hang the bracket for pulling off the wheel covers
at the edge of one of the openings in the cover.
›
Tap the
functional area and select the vehicle
Push the wheel wrench through the bracket, sup-
port it on the tire and pull off the cover.
›
load condition.
Install
Troubleshooting
Place the cover on the intended valve section on
the rim.
›
Functional restriction / system fault
If an anti-theft wheel bolt is used, it must be in the
position marked on the cover.
flashing
Stop the engine and start again.
If the indicator light flashes again after the engine
›
Press the trim, starting at the valve, into the rim on
both sides until it engages around the entire cir-
cumference.
›
›
starts, there is a problem with the system.
Continue driving, exercising appropriate caution,
and seek the help of a specialist garage.
›
NOTICE
Use hand pressure, do not hit the wheel cover.
▶
Pull off and install the aero cover
Applies to factory installed covers or covers deliv-
ered with ŠKODA original accessories.
