Instruments and controls -> Turn signal lever for Your Subaru Forester SUV 2024

Turn signal lever 239  
3-15. Turn signal lever  
.
Turn the switch to “OFF” (for Canada  
models).  
For Canada models  
1
2
Headlight switch  
Fog light switch  
1
2
3
4
Right turn  
The indicator light on the combination  
meter will illuminate when the front fog  
lights are illuminated.  
Lane change right signal  
Lane change left signal  
Left turn  
The front fog lights will turn on when the  
fog light switch is placed in the “ ” position  
while the headlights are in the following  
condition.  
If the lever does not return after cornering,  
return the lever to the neutral position by  
hand.  
.
The headlight switch is in the “  
position with the low beam mode  
selected.  
For models with the auto on/off head-  
lights, while the headlight switch is in  
the “AUTO” position and the low beam  
headlights turn on automatically.  
To signal a lane change, push the turn  
signal lever up or down slightly and hold it  
during the lane change. The lever will  
return automatically to the neutral position  
when you release it.  
.
To turn off the front fog lights, perform the  
following.  
.
Turn the switch to “ ” (except for  
Canada models).  
– CONTINUED –  
Wiper and washer  
240  
.
In freezing weather, be sure that  
the blade rubbers are not frozen  
to the windshield or rear window  
before switching on the wipers.  
Attempting to operate the wiper  
with the blades frozen to the  
window glass could cause not  
only the blade rubbers to be  
damaged but also might cause  
the wiper motor to fail. If the blade  
rubbers are frozen to the window  
glass, be sure to operate the  
defroster, windshield wiper dei-  
cer (if equipped) or rear window  
defogger before turning on the  
wiper.  
& One-touch lane changer  
3-16. Wiper and washer  
To flash the turn signal and turn signal  
indicator light three times, push the turn  
signal lever up or down slightly and  
immediately release it.  
WARNING  
In freezing weather, do not use the  
windshield washer until the wind-  
shield is sufficiently warmed by the  
defroster.  
NOTE  
The operational/non-operational  
setting of the one-touch lane changer  
can be changed by a SUBARU dealer.  
Contact the nearest SUBARU dealer for  
details. The setting can also be chan-  
ged by operating the combination me-  
ter display (color LCD). For details,  
refer to “Vehicle Setting” P199.  
Otherwise the washer fluid can  
freeze on the windshield, blocking  
your view.  
CAUTION  
.
.
Do not operate the washer con-  
tinuously for more than 10 sec-  
onds, or when the washer fluid  
tank is empty. This may cause  
overheating of the washer motor.  
Check the washer fluid level fre-  
quently, such as at fuel stops.  
.
If the wipers stop during opera-  
tion because of ice or some other  
obstruction on the window, this  
might cause the wiper motor to  
fail even if the wiper switch is  
turned off. If this occurs,  
promptly stop the vehicle in a  
safe place, turn the ignition  
switch to the “LOCK”/“OFF” po-  
sition and clean the window glass  
to allow proper wiper operation.  
Do not operate the wipers when  
the windshield or rear window is  
dry. This may scratch the glass,  
damage the blade rubbers and  
might cause the wiper motor to  
fail. Before operating the wiper  
on a dry windshield or rear win-  
dow, always use the windshield  
washer.  
.
Use clean water if windshield  
washer fluid is unavailable. In  
areas where water freezes in  
winter, use SUBARU Windshield  
Washer Fluid or the equivalent.