Driving and operating -> Automatic transmission for Your Vauxhall Grandland X SUV 2020

Driving and operating  
147  
To shift into B:  
1. Shift into D.  
2. Push the selector backwards  
without passing the point of  
resistance.  
To shift from B to D, push the selector  
backwards without passing the point  
of resistance.  
In manual mode, M and the number  
of the selected gear is indicated.  
R indicates reverse gear.  
N indicates neutral position.  
P indicates park position.  
Automatic transmission  
The automatic transmission permits  
automatic gearshifting (automatic  
mode) or manual gearshifting  
(manual mode).  
Manual shifting is possible in manual  
mode by tapping the selector lever to  
+ or - 3 148.  
Gear selection  
One-pedal driving  
With one-pedal driving, the  
Transmission display  
accelerator pedal can be used to  
control the deceleration of the vehicle  
down to a complete stop.  
Quick releasing of the accelerator  
pedal will result in aggressive  
deceleration. Slow releasing of the  
accelerator pedal will allow the  
deceleration of the vehicle to be  
adjusted as desired.  
To use one-pedal driving, shift into B.  
B is only selectable when the vehicle  
is in D. Press the accelerator pedal to  
achieve the desired speed. The  
deceleration provided by one-pedal  
driving provides full regenerative  
braking by charging the high voltage  
battery.  
Move the selector lever in the shifting  
gate as shown in the illustration  
above.  
The mode or selected gear is shown  
in the Driver Information Centre.  
In automatic mode, the driving  
programme is indicated by D.  
148  
Driving and operating  
P : park position, front wheels are  
locked, engage only when the  
vehicle is stationary and the  
parking brake is applied  
R : reverse gear, engage only when  
the vehicle is stationary  
N : neutral  
Engine braking  
To utilise the engine braking effect,  
select a lower gear in good time when  
driving downhill, see manual mode.  
Manual mode  
Rocking the vehicle  
Rocking the vehicle is only  
permissible if the vehicle is stuck in  
sand, mud or snow. Move the selector  
lever between D and R in a repeat  
pattern. Do not race the engine and  
avoid sudden acceleration.  
D : automatic mode  
M : manual mode  
+ : upshift in manual mode  
-
: downshift in manual mode  
The selector lever is locked in P and  
can only be moved when the ignition  
is on and the brake pedal is applied.  
The engine can only be started with  
the selector lever in position P or N.  
When position N is selected, press  
the brake pedal or apply the parking  
brake before starting.  
Do not accelerate while engaging a  
gear. Never depress the accelerator  
pedal and brake pedal at the same  
time.  
When a gear is engaged, the vehicle  
slowly begins to creep when the  
brake is released.  
Parking  
Move selector lever out of position D  
towards the left in position M.  
Tap the selector lever to the front + to  
shift to a higher gear.  
Tap the selector lever to the rear - to  
shift to a lower gear.  
If a higher gear is selected when  
vehicle speed is too low, or a lower  
gear when vehicle speed is too high,  
the shift is not executed. This can  
cause a message in the Driver  
Information Centre.  
Apply the parking brake and engage  
P.  
 
Driving and operating  
149  
In manual mode, no automatic  
shifting to a higher gear takes place  
at high engine revolutions.  
enables the driver to select  
manually first, second or third  
gear for starting off.  
Interruption of power supply  
In the event of an interruption of  
power supply, the selector lever  
cannot be moved out of the P  
position.  
Gear shift indication  
Kickdown  
Pressing down the accelerator pedal  
beyond the kickdown detent will lead  
to maximum acceleration  
independent of selected driving  
mode. The transmission shifts to a  
lower gear depending on engine  
speed.  
The symbol R or S with a number  
beside it is indicated when  
gearshifting is recommended for fuel  
saving reasons.  
Shift indication appears only in  
manual mode.  
If the vehicle battery is discharged,  
start the vehicle using jump leads  
3 242.  
If the vehicle battery is not the cause  
of the fault, release the selector lever.  
1. Apply the parking brake.  
2. Release the selector lever trim  
from the centre console. Poke  
with a finger into the leather  
socket below the selector lever  
and push the trim upwards.  
Electronic driving  
programmes  
Fault  
In the event of a fault a message is  
displayed in the Driver Information  
Centre.  
Following a cold start, the  
operating temperature  
programme increases engine  
speed to quickly bring the  
catalytic converter to the required  
temperature.  
Vehicle messages 3 106.  
Electronic transmission control  
enables only third gear. The  
transmission no longer shifts  
automatically.  
Do not drive faster than 62 mph.  
Have the cause of the fault remedied  
by a workshop.  
Special programmes  
automatically adapt the shifting  
points when driving up inclines or  
down hills.  
In snowy or icy conditions or on  
other slippery surfaces, the  
electronic transmission control  
150  
Driving and operating  
3. Push down the button and move  
the selector lever out of P. Have  
the cause of the power supply  
interruption remedied by a  
workshop.  
When clutch slip is detected for a  
specific time, the engine power will be  
reduced. A warning is displayed in the  
Driver Information Centre. Release  
the clutch.  
Manual transmission  
4. Mount the selector lever trim onto  
Caution  
the centre console and refit.  
It is not advisable to drive with the  
hand resting on the selector lever.  
Gear shift indication 3 96.  
Stop-start system 3 138.  
To engage reverse on 6-speed  
transmission, depress the clutch  
pedal, pull the ring under the selector  
lever and move the selector lever  
quite to the left and front.  
If the gear does not engage, set the  
selector lever to neutral, release the  
clutch pedal and depress again. Then  
repeat gear selection.  
Do not slip the clutch unnecessarily.  
When operating, depress the clutch  
pedal completely. Do not use the  
pedal as a foot rest.