Get Lighting Guide for Vauxhall Grandland X SUV 2020

112

Lighting

Entry lighting ............................ 121

Exit lighting .............................. 121

Battery discharge protection .... 121

Exterior lighting

Light switch

Lighting

Exterior lighting .......................... 112

Light switch .............................. 112

Automatic light control ............. 113

High beam ............................... 113

Headlight flash ......................... 113

Headlight range adjustment .... 114

Headlights when driving

abroad .................................... 114

Daytime running lights ............. 114

LED headlights ........................ 114

Hazard warning flashers .......... 117

Turn lights ................................ 117

Front fog lights ......................... 118

Rear fog light ........................... 118

Parking lights ........................... 119

Reversing lights ....................... 119

Misted light covers ................... 119

Interior lighting ........................... 119

Instrument panel illumination

control ..................................... 119

Interior lights ............................ 120

Reading lights .......................... 120

Sunvisor lights ......................... 120

Turn light switch:

AUTO : automatic light control

switches automatically

between daytime running

light and headlight

8

9

: sidelights

: headlights

When switching on the ignition,

automatic light control is active.

Control indicator 8 3 98.

Lighting features ........................ 121

Centre console lighting ............ 121

Lighting

113

Daytime running light 3 114.

Pull to deactivate high beam.

High beam assist 3 114.

Tail lights

Tail lights are illuminated together

with low / high beam and sidelights.

Automatic headlight activation

During poor lighting conditions the

headlights are switched on.

Additionally, headlights are switched

on if the windscreen wipers have

been activated for several wipes.

Headlight flash

Automatic light control

Tunnel detection

When a tunnel is entered, headlights

are switched on immediately.

High beam

Pull to activate the headlight flash.

Pull to deactivate high beam.

When the automatic light control

function is switched on and the

engine is running, the system

switches between daytime running

lights and headlights automatically

depending on the external lighting

conditions and information given by

the wiper system.

Make sure the sensor is not blocked

3 10, 3 38.

Push to switch from low to high beam.

114

Lighting

The system switches between

daytime running lights and low beam

automatically, depending on the

lighting conditions.

Headlight range adjustment Headlights when driving

abroad

Manual headlight range

When driving in countries where

adjustment

traffic drives on the opposite side of

the road, the headlights have to be

adjusted.

LED headlights

LED headlight system contains a

variety of particular LEDs in each

headlight which enables the control of

the adaptive forward lighting

functions.

1. With the engine switched off, pull

the indicator lever and hold.

2. Start the engine.

3. Hold the indicator lever for

another 5 seconds.

Light distribution and intensity of light

are variably triggered depending on

the lighting conditions, road type and

driving situation. The vehicle adapts

the headlights automatically to the

situation to enable optimal light

performance for the driver.

Some adaptive forward lighting

functions of the LED headlights can

be deactivated or activated in the

vehicle personalisation menu. Select

the relevant setting in Settings I

Vehicle in the Info Display.

4. Release the indicator lever.

If the headlights are adjusted, a

message is displayed in the Driver

Information Centre each time the

To adapt headlight range to the

engine is started.

vehicle load to prevent dazzling, turn

thumb wheel ? to required position.

To reverse the adjustment of the

headlights, repeat the steps

described above.

0 : front seats occupied

1 : all seats occupied

2 : all seats occupied and load

compartment laden

Daytime running lights

Daytime running lights increase

3 : driver's seat occupied and load

compartment laden

visibility of the vehicle during daylight.

Vehicle personalisation 3 107.

They are switched on automatically

when the engine is running.

The lighting functions are only

available with light switch in position

AUTO.

Lighting

115

allowing distant objects to be

recognised across the entire width of

the road.

Country light

Corner light

Town light

Activated automatically at a speed

between 34 mph and 71 mph when

driving in rural areas. The illumination

of the current lane and the side of the

road is improved. Oncoming and

preceding vehicles are not dazzled.

Activated at a speed of up to 25 mph

when turning off. The light consists of

particular LEDs which illuminate the

direction of travel. These LEDs are

triggered depending on the steering

angle or the activation of the turn

lights.

Activated automatically at a speed up

to approx. 34 mph and in situations

with exterior ambient light. The light is

wide and symmetrical. If the speed is

below 19 mph, the headlamps are

slightly swiveled to the outside to

allow an earlier recognition of

Motorway light

Adverse weather light

pedestrians and objects on each side

of the road. A special beam pattern is

designed to avoid glare for other road

users.

Activated automatically at a speed

above 71 mph. Illumination is

adapted to the higher speed driven on

motorways. If there is no oncoming

traffic, the visibility on the side of the

vehicle is increased. The visibility

range raises from 70 m to 140 m

Controlled by wiper or rain sensor.

The wide light distribution – slightly

swiveled to the outside – enables

improved orientation at the edge of

the road. The intensity of the light in

the far distance is increased in order

116

Lighting

to recognise objects and markings on

the right road side and obstacles on

the lane despite the weather

condition. By lowering the reflection

on wet roads the oncoming traffic is

less dazzled. Adverse weather light is

activated up to a speed to 43 mph.

right or left side can be triggered or

faded out particularly according to the

traffic situation. This gives the best

light distribution without dazzling

other road users. Once activated,

high beam assist remains active and

switches high beam on and off

depending on surrounding

Activation

Curve light

conditions. The latest setting of the

high beam assist will remain after the

ignition is switched on again.

Activate the high beam assist by

pressing f. The LED of the button

illuminates if the high beam assist is

activated. High beam is switched on

automatically at a speed above

15 mph. High beam is switched off at

a speed below 9 mph, but high beam

assist remains active.

Particular LEDs, based on steering

angle and speed, are additionally

triggered to improve lighting in

curves. This function is activated at

speeds from 25 mph to 43 mph.

High beam assist includes a special

motorway mode. When driving faster

than 71 mph on motorways, the light

beam becomes smaller to avoid

dazzling of oncoming traffic. When

following vehicles ahead or passing,

dazzling for these vehicles is

reduced.

High beam assist

This feature activates the high beam

at night when the vehicle speed is

faster than 15 mph.

The green control indicator f

illuminates continuously when the

high beam assist is activated, the blue

7 illuminates when high beam is on.

The camera in the windscreen

detects the lights of oncoming or

preceding vehicles. Each LED on

Control indicator f 3 99, 7 3 99.

Lighting

117

Pushing left indicator lever once

switches on manual high beam

without high beam assist.

High beam assist switches

automatically to low beam when:

force of deceleration. They are

Fault in LED headlight system

switched off automatically the first

time you accelerate.

When the system detects a failure in

the LED headlight system, it selects a

preset position to avoid dazzling of

oncoming traffic. A warning is

displayed in the Driver Information

Centre.

Turn lights

●

Driving in urban areas.

Camera detects heavy fog.

Front or rear fog lights are

switched on.

Hazard warning flashers

If there are no restrictions detected,

the system switches back to high

beam.

Deactivation

Deactivate the high beam assist by

pressing f.

If a headlight flash is activated when

the high beam assist is activated and

low beam is on, the high beam assist

will be deactivated. The system

changes to high beam.

If a headlight flash is activated when

the high beam assist is activated and

high beam is on, the high beam assist

will be deactivated. The system

changes to low beam.

up

: right turn lights

down : left turn lights

A resistance point can be felt when

moving the indicator lever.

Constant flashing is activated when

the indicator lever is being moved

beyond the resistance point. It is

deactivated when the steering wheel

Operated by pressing ¨.

When braking in an emergency, the

hazard warning flashers are switched

on automatically depending on the

To reactivate the high beam assist,

flash the headlights again.

118

Lighting

is moved in the opposite direction or

indicator lever is manually moved

back to its neutral position.

Front fog lights

Rear fog light

Activate temporary flashing by

holding the indicator lever just before

the resistance point. Turn lights will

flash until indicator lever is being

released.

To activate three flashes, tap the

indicator lever briefly without passing

the resistance point.

If you forget to cancel the turn lights

for more than 20 seconds, the volume

of the audible signal will increase if

the speed is above 40 mph.

Operated by pressing >.

Operated by pressing r.

Light switch in position AUTO:

switching on front fog lights will switch

headlights on automatically.

Light switch in position AUTO:

switching on rear fog light will switch

headlights on automatically.

Light switch in position 8: rear fog

light can only be switched on with

front fog lights.

The vehicle rear fog light is

deactivated when towing a trailer or a

plug is connected with the socket,

e.g. when a bicycle carrier is used.

Lighting

119

Parking lights

Reversing lights

Interior lighting

Instrument panel

illumination control

The reversing light comes on when

the ignition is on and reverse gear is

selected.

Misted light covers

The inside of the light housing may

mist up briefly in poor, wet and cold

weather conditions, in heavy rain or

after washing. The mist disappears

quickly by itself. To help, switch on the

headlights.

When the vehicle is parked, the

parking lights on one side can be

activated:

1. Switch off ignition.

Brightness of the following lights can

be adjusted when the exterior lights

are on:

2. Move the lever all the way up

(right parking lights) or down (left

parking lights).

Confirmed by a signal and the

corresponding turn lights control

indicator.

●

instrument panel illumination

Info Display

illuminated switches and

operation elements

Turn thumb wheel A and hold until

the desired brightness is obtained.

120

Lighting

Rear courtesy lights

Illuminate in conjunction with the front

courtesy light.

Interior lights

During entry and exit of the vehicle,

the front and rear courtesy lights

automatically switch on and then off

after a delay.

Reading lights

Notice

In the event of an accident with

airbag deployment the courtesy

lights are turned on automatically.

Front courtesy light

Illustration shows rear courtesy lights.

Sunvisor lights

Illuminates when the cover is opened.

Operated by pressing s and t in the

courtesy lights.

w

: automatic switching on

and off

press u : on

press v : off

Lighting

121

This function can be activated or

deactivated in the vehicle

personalisation.

Lighting features

Centre console lighting

Vehicle personalisation 3 107.

A spotlight integrated in the overhead

console illuminates the centre

console when headlights are

switched on.

The following lights will additionally

switch on when the driver's door is

opened:

●

illumination of some switches

Driver Information Centre

door pocket lights

Entry lighting

Welcome lighting

Some or all of the following lights are

switched on for a short time by

unlocking the vehicle with the radio

remote control:

Exit lighting

The following lights are switched on

when the ignition is switched off:

●

headlights

interior lights

centre console lighting

●

headlights

puddle lights

interior lights

They will switch off automatically after

a delay. This function works only in

the dark.

The number of activated lights

depends on the surrounding light

conditions.

The lighting switches off immediately

Battery discharge protection

when the ignition is switched on.

To prevent discharge of the vehicle

battery when the ignition is switched

off, some interior lights are switched

off automatically after some time.

Starting off 3 17.

Lighting for Your Vauxhall Grandland X SUV 2020

Popular Manuals