Vehicle care -> Jump starting for Your Vauxhall Mokka SUV 2020

Vehicle care  
209  
The following applies to tyres fitted  
opposing the rolling direction:  
A discharged battery can already  
freeze at a temperature of 0 °C.  
Defrost the frozen battery before  
connecting jump leads.  
Wear eye protection and  
protective clothing when  
handling a battery.  
Use a booster battery with the  
same voltage (12 Volts). Its  
capacity (Ah) must not be much  
less than that of the discharged  
battery.  
Use jump leads with insulated  
terminals and a cross section of  
at least 16 mm2 (25 mm2 for  
diesel engines).  
Jump starting  
Do not start with a quick charger.  
A vehicle with a discharged battery  
can be started using jump leads and  
the battery of another vehicle.  
Driveability may be affected.  
Have the defective tyre renewed  
or repaired as soon as possible  
and fit it instead of the spare  
wheel.  
Drive particularly carefully on wet  
and snow-covered road  
surfaces.  
9 Warning  
Be extremely careful when starting  
with jump leads. Any deviation  
from the following instructions can  
lead to injuries or damage caused  
by battery explosion or damage to  
the electrical systems of both  
vehicles.  
Do not disconnect the discharged  
battery from the vehicle.  
9 Warning  
Switch off all unnecessary  
electrical consumers.  
Do not lean over the battery  
during jump starting.  
Do not allow the terminals of one  
lead to touch those of the other  
lead.  
Avoid contact of the battery with  
eyes, skin, fabrics and painted  
surfaces. The fluid contains  
sulphuric acid which can cause  
injuries and damage in the event  
of direct contact.  
The vehicles must not come into  
contact with each other during  
the jump starting process.  
Never expose the battery to  
naked flames or sparks.  
210  
Vehicle care  
Apply the parking brake,  
transmission in neutral,  
automatic transmission in P.  
Open the positive terminal  
protection caps of both batteries.  
3. Connect the black lead to the  
negative terminal of the booster  
battery.  
4. Connect the other end of the black  
lead to a vehicle grounding point,  
such as the engine block or an  
engine mounting bolt. Connect as  
far away from the discharged  
battery as possible, however at  
least 60 cm.  
4. Switch on electrical consumers  
(e.g. headlights, heated rear  
window) of the vehicle receiving  
the jump start.  
5. Reverse above sequence exactly  
when removing leads.  
Route the leads so that they cannot  
catch on rotating parts in the engine  
compartment.  
To start the engine:  
1. Start the engine of the vehicle  
providing the jump.  
2. After five minutes, start the other  
engine. Start attempts should be  
made for no longer than  
15 seconds at an interval of  
1 minute.  
3. Allow both engines to idle for  
approx. three minutes with the  
leads connected.  
Lead connection order:  
1. Connect the red lead to the  
positive terminal of the booster  
battery.  
2. Connect the other end of the red  
lead to the positive terminal of the  
discharged battery.