Maintenance and service -> Bulb replacement for Your Volvo XC40 SUV 2020

Lamp types vary depending on model and

equipment level. If a bulb¹⁴breaks, it can be

replaced according to the method described

in the Owner's Manual.

The exterior lighting of the car uses a number

of different lamps. An LED¹⁶type lamp must

be replaced by a workshop. An authorised

Volvo workshop is recommended.

If an error message remains after the bro-

ken bulb has been replaced then we rec-

ommend visiting an authorised Volvo

workshop.

If a fault occurs in LED¹⁵lamps, the entire

lamp unit usually must be replaced.

Lamps, front

Outside lighting such as headlamps and

rear lamps may temporarily have conden-

sation on the inside of the lens. This is nor-

mal, all exterior lighting is designed to

withstand this. Condensation is normally

vented out of the lamp housing when the

lamp has been switched on for a time.

For information about bulbs not covered in

this Owner's Manual, contact a Volvo

dealer or an authorised Volvo workshop.

WARNING

The car's electrical system must be in igni-

tion position 0 when replacing bulbs.

Related information

•

Replacing the rear direction indicator bulb

Daytime running lights/position lamps/

direction indicators (LED)

(p. 604)

•

Never touch the glass part of the bulbs

with your fingers. Grease from your fingers

is vaporised by the heat, coating the reflec-

tor and then causing damage.

Main beam (LED)

Changing brake light bulb (p. 605)

Replacing the rear fog lamp bulb (p. 606)

Bulb replacement (p. 603)

•

Dipped beam (LED)

Front fog lamps/cornering lights* (LED)

14

Some cars have no bulbs.

LED (Light Emitting Diode)

LED (Light Emmitting Diode)

15

16

}}

* Option/accessory. 603

MAINTENANCE AND SERVICE

||

Lamps, rear

Replacing the rear direction

indicator bulb

Bulbs for rear direction indicators are located

behind the panel in the side of the cargo area.

3. Unscrew and remove the spring bolt anti-

clockwise, press the clips into the sides

and remove the supporting bridge. It is

easiest to allow the screw to remain in the

supporting bridge.

Brake light - central, high-level (LED)

Fog lamp

1. Press in the panel hatch at the upper edge

to detach it.

Position lamps (LED)

Direction indicators

Brake lights

2. Move the insulation aside to access the

supporting bridge.

Reversing lamps (LED)

Related information

Lighting control (p. 138)

•

604

MAINTENANCE AND SERVICE

Changing brake light bulb

Bulbs for brake lights are located behind the

panel in the side of the cargo area.

Never touch the glass part of the bulbs

with your fingers. Grease from your fingers

is vaporised by the heat, coating the reflec-

tor and then causing damage.

Related information

Bulb replacement (p. 603)

•

4. Undo the grey bulb holder by turning it

anticlockwise and pulling it out.

5. Remove the bulb by pressing it in and

turning anticlockwise.

1. Press in the panel hatch at the upper edge

to detach it.

6. Fit a new bulb by pressing it in and turning

it clockwise.

2. Move the insulation aside to access the

brake light bulb.

7. Attach the bulb holder by turning it clock-

wise.

8. Fit the supporting bridge with associated

spring bolt and make sure that the clips

align in the correct position. Tighten the

spring bolt until it stops, max. 2 Nm (1.5 ft

lbs).

9. Move back the insulation and then hook in

the panel and press it back into place.

}}

605

MAINTENANCE AND SERVICE

||

Related information

Replacing the rear fog lamp bulb

The rear foglight is fitted in the rear bumper

•

on the driver's side.

•

3. Undo the black bulb holder by turning it

anticlockwise and pulling it out.

4. Remove the bulb by pressing it in and

turning anticlockwise.

The rear fog light is only fitted on the driver's side.

1. Loosen the foglight unit on the driver's

side by inserting a flat object, such as a

table knife or a screwdriver, on the bulb

kit's narrower short side of the keypad and

then prize the foglight unit out.

5. Fit a new bulb by pressing it in and turning

it clockwise.

6. Attach the bulb holder by turning it clock-

wise.

7. Move back the insulation and then hook in

the panel and press it back into place.

2. Unplug the connector.

3. Undo the bulb holder by turning it anti-

clockwise and pulling it out.

4. Remove the bulb by pressing it in and

turning anticlockwise.

Never touch the glass part of the bulbs

with your fingers. Grease from your fingers

is vaporised by the heat, coating the reflec-

tor and then causing damage.

5. Fit a new bulb by pressing it in and turning

it clockwise.

6. Attach the bulb holder by turning it clock-

wise.

606

MAINTENANCE AND SERVICE

7. Plug in the connector.

Bulb specifications

Cleaning the interior

Specifications for replaceable bulbs.

Use cleaning agents and car care products

recommended by Volvo. Clean regularly, and

deal with stains straight away. Vacuuming is

important prior to using cleaning agents.

8. Insert the hook on the wide part of the

foglight unit in the rear bumper and rotate

the unit inwards so that the clips engage.

Contact a workshop¹⁷if faults occur in lamps

other than bulbs. If a fault occurs in LED¹⁸

lamps, the entire lamp unit usually must be

replaced.

Related information

•

W^A

24

21

Certain items of coloured clothing (e.g.

dark jeans and suede garments) may

stain the upholstery. If this occurs, it is

important to clean and treat these

parts of the upholstery as soon as pos-

sible.

•

Function

Type

•

Rear direction indicators

Brake lights

PY24W

H21W LL

Rear fog lamp

21

Never use strong solvents such as

washer fluid, pure petrol or white spirit

or concentrated alcohol to clean the

interior, since this may damage the

upholstery as well as other interior

materials.

A

Watt

Related information

Bulb replacement (p. 603)

•

•

Never spray the cleaning agent directly

onto components that have electrical

buttons and controls. Wipe them

instead using a moistened cloth con-

taining the cleaning agent.

Sharp objects and Velcro may damage

the fabric upholstery.

•

Only use cleaning agents on the type

of material for which they were

intended.

17

18

An authorised Volvo workshop is recommended.

LED (Light Emitting Diode)

}}

607

MAINTENANCE AND SERVICE

||

Related information

Cleaning the centre display

•

Dirt, stains and grease from fingers can affect

the centre display's performance and reada-

bility. Clean the screen frequently with a

microfibre cloth.

The microfibre cloth used to clean the cen-

tre display must be free from sand and dirt.

•

•

When cleaning the centre display, only use

gentle pressure on the screen. Heavy pres-

sure can damage the screen.

•

•

Do not spray any liquid or caustic chemi-

cals directly on the centre display. Do not

use window cleaning agent, other cleaning

agents, aerosol spray, solvents, alcohol,

ammonia or cleaning agent containing

abrasive.

1. Turn off the centre display with a long

press on the home button.

Never use abrasive cloths, paper towels or

tissue paper, since they may scratch the

centre display.

2. Wipe the screen with the microfibre cloth

supplied or use another microfibre cloth of

equivalent quality. Wipe the screen with a

clean and dry microfibre cloth using small

circular movements. If necessary, lightly

moisten the microfibre cloth with clean

water.

Related information

•

•

3. Activate the display with a short press on

the home button.

•

•

608

* Option/accessory.

MAINTENANCE AND SERVICE

•

Cleaning fabric upholstery and

headlining

It is recommended to use a fabric cleaning

agent when cleaning textile fabric. Clean if

necessary, and treat stains straight away.

Always clean the entire upholstery, even

there are only individual stains. This is to

avoid water rings.

Never scrape or rub a stain since this may

damage the upholstery.

Do not remove the upholstery for cleaning.

Cleaning the headlining

1. Brush the headlining carefully using a soft

brush.

Never use stain removing agent or strong

solvents, they could damage the uphols-

tery.

2. Follow the instructions for the fabric

cleaning agent.

3. Then use a soft and lint-free cloth to wipe

the headlining.

Cleaning fabric upholstery

1. Start by vacuum cleaning the upholstery.

2. Follow the instructions for the fabric

cleaning agent.

Careless cleaning can damage the headlin-

ing.

3. When cleaning fabric, a spray extraction

cleaner is recommended for suction of the

washing fluid and subsequent water rins-

ing.

Related information

•

Some coloured clothing (such as jeans and

suede garments) may stain the fabric

upholstery. Heavy stains such as oil may

be difficult to remove.

•

}}

* Option/accessory. 609

MAINTENANCE AND SERVICE

•

Cleaning the seatbelts

Cleaning floor mats and inlay mats

Use cleaning agents and car care products

recommended by Volvo. Clean regularly, and

deal with stains straight away. Vacuuming is

important prior to using cleaning agents.

Use water and a synthetic detergent. A special

textile cleaning agent is available from Volvo

retailers. Ensure that the seatbelt is dry before

allowing it to retract.

Use cleaning agents and car care products

recommended by Volvo. Clean regularly, and

deal with stains straight away. Vacuuming is

important prior to using cleaning agents.

Remove inlaid carpets for separate cleaning of

the floor carpet and the inlaid carpets. Each

inlay mat is secured with pins.

1. Remove the inlay mat by taking hold of

the inlay mat at each pin and lifting the

mat straight up.

Related information

•

2. Use a vacuum cleaner to remove dust and

dirt.

•

The inlay mats must not be swung around

without care or hit against objects to

remove dirt since this can crack the inlay

mats.

•

•

3. A special textile cleaner is recommended

for stains on the floor mat after vacuum-

ing. Use cleaning agent recommended by

Volvo.

4. After cleaning, fit the inlay mat in place by

pressing it in at each pin.

610

* Option/accessory.

MAINTENANCE AND SERVICE

3. Thoroughly dampen the stain using the

sponge, allow the sponge to absorb the

stain without scrubbing.

Cleaning leather upholstery*

WARNING

Use cleaning agents and car care products

recommended by Volvo. Clean regularly, and

deal with stains straight away. Vacuuming is

important prior to using cleaning agents.

Only use one inlaid mat at each seat, and

check before setting off that the mat by the

driver's seat is firmly affixed and secured in

the pins so that it does not get caught

adjacent to and under the pedals.

4. Wipe the stain with a soft cloth and allow

the leather to dry thoroughly.

Protecting the leather upholstery

1. Apply a small amount of leather protective

agent to a cloth and then apply it to the

leather in light circular motions.

Volvo's leather upholstery* is treated to pre-

serve its original appearance.

Related information

•

Leather upholstery* is a natural product that

changes and acquires a beautiful patina over

time. Regular cleaning and treatment are

required in order that the properties and col-

ours of the leather shall be preserved. Volvo

offers a comprehensive product, Volvo Leather

Care KitWipes, for cleaning and treatment of

leather upholstery. The protective outer layer

of the leather is preserved when this is used

according to the instructions.

2. Allow to dry for about 20 minutes.

> Protecting the leather upholstery

makes it more resistant to the stresses

from the sun's UV radiation.

•

Related information

•

•

To achieve results that are as good as possi-

ble, Volvo recommends cleaning and applica-

tion of the protective cream one to four times

per year (or more frequently if required). Volvo

Leather Care Kit/Wipes is available from Volvo

dealers.

•

•

Cleaning the leather upholstery

1. Apply the leather cleaner to a damp

sponge and squeeze until a foam is cre-

ated.

2. Use the sponge on the stain in a circular

motion.

* Option/accessory. 611

MAINTENANCE AND SERVICE

Cleaning the leather steering

wheel

Cleaning interior plastic, metal and

wood parts

Use cleaning agents and car care products

recommended by Volvo. Clean regularly, and

deal with stains straight away.

A fibrillated fibre or microfibre cloth, lightly

moistened with water, available from Volvo

dealers, is recommended for cleaning interior

parts and surfaces.

•

Use cleaning agents and car care products

recommended by Volvo. Clean regularly, and

deal with stains straight away. Vacuuming is

important prior to using cleaning agents.

Leather needs to breathe. Never cover the

leather steering wheel with protective plastic.

We recommend Volvo Leather Care Kit/Wipes

for cleaning the leather steering wheel. First

remove dirt, dust, etc. with a damp sponge or

cloth.

•

Do not scrape or rub stains. Never use strong

stain removers, either.

Do not use solvent that contains alcohol

when cleaning the glass for the driver dis-

play.

Sharp objects, e.g. rings, can damage the

leather on the steering wheel.

Related information

•

Keep in mind that high gloss surfaces are

easily scratched. Clean these surfaces with

a clean, dry microfibre cloth using small,

circular motions. If needed, dampen the

microfibre cloth with a little clean water.

•

Related information

•

•