Wheels and tires -> Spare wheel for Your Volvo XC60 SUV 2020

WHEELS AND TIRES  
Spare wheel13  
4. Tighten the wheel bolts in a crisscross pat-  
tern (as shown in illustration). It is impor-  
tant that the wheel bolts are securely  
The spare wheel is a Temporary Spare and  
can be used to temporarily replace a punc-  
tured tire on one of the vehicle's regular  
wheels.  
The spare tire is only intended for temporary  
use. Replace it with a normal wheel as soon as  
possible.  
After inflating a tire, always replace the  
valve cap to help prevent valve damage  
caused by gravel, dirt, etc.  
tightened. Tighten to 140 Nm (103 ft. lbs.).  
Use a torque wrench to check torque.  
Use plastic valve caps only. Metal caps  
could corrode and become difficult to  
remove.  
The driving characteristics of the vehicle  
change and ground clearance reduces when  
the spare wheel is used. Do not wash the vehi-  
cle in an automatic car wash while using the  
Temporary Spare.  
Related information  
When changing wheels (p. 530)  
Hoisting the vehicle (p. 575)  
Jack* (p. 531)  
The recommended tire pressure must be  
maintained regardless of at which position the  
temporary spare wheel is used on the vehicle.  
Tool kit (p. 530)  
Removing a wheel (p. 532)  
Saving a new inflation pressure in the  
If the spare wheel is damaged, a new one can  
be purchased from a Volvo retailer.  
monitoring system* (p. 527)  
5. Press the plastic covers onto the wheel  
bolts.  
Checking tire pressure (p. 523)  
6. Check the tire inflation pressure and store  
the new inflation pressure in the tire pres-  
sure monitoring system*.  
WARNING  
Current legislation prohibits the use of the  
"Temporary Spare" tire other than as a  
temporary replacement for a punctured  
tire. It must be replaced as soon as possi-  
ble by a standard tire. Road holding and  
handling may be affected with the "Tempo-  
rary Spare" in use. Do not drive faster than  
80 km/h (50 mph).  
WARNING  
The wheel bolts may need to be tightened  
again several days after a wheel change.  
Temperature fluctuations and vibrations  
can cause them to loosen slightly.  
13  
Not available on all models.  
}}  
* Option/accessory. 535  
 
WHEELS AND TIRES  
||  
Handling spare tires  
Follow these instructions regarding handling  
the spare wheel.  
WARNING  
The vehicle must never be driven with  
more than one "Temporary Spare" tire  
mounted.  
The vehicle must not be driven with wheels  
of different dimensions or with a spare tire  
other than the one that came with the vehi-  
cle. The use of different size wheels can  
seriously damage your vehicle's transmis-  
sion.  
Driving with a spare wheel may alter  
the driving characteristics of the vehi-  
cle. Replace the spare wheel with a  
normal wheel as soon as possible.  
The spare wheel is smaller than the  
normal wheel, which affects the vehi-  
cle's ground clearance. Watch for high  
curbs and do not wash the vehicle in  
an automatic car wash when a spare  
wheel is mounted.  
Related information  
When changing wheels (p. 530)  
Recommended tire pressure (p. 525)  
This illustration is generic and appearance may vary.  
Follow the manufacturer's recom-  
mended tire inflation pressure for the  
spare wheel.  
The spare tire is located under the floor of the  
cargo compartment and is held in place by  
two straps. The foam block contains all tools  
needed to change a wheel.  
On all-wheel drive vehicles, the drive  
on the rear axle can be disconnected.  
1. Lift the rear edge of the cargo compart-  
ment floor.  
If the spare wheel is mounted on the  
front axle, snow chains must not be  
used.  
2. Release the straps and lift out the spare  
wheel.  
The spare wheel must not be repaired.  
Related information  
Tool kit (p. 530)  
Removing a wheel (p. 532)  
536