Key, locks and alarm -> Alarm for Your Volvo Xc90 SUV 2020

KEY, LOCKS AND ALARM  
Alarm  
Alarm indicator  
In the event of alarm system failure  
If a problem is detected in the alarm  
system, a symbol and the message  
Alarm system failure Service  
The alarm emits sound and light signals if  
anyone without a valid remote key attempts  
to break into the vehicle or interferes with the  
start battery or alarm siren.  
required will appear in the instru-  
ment panel. Contact a workshop - an author-  
ized Volvo workshop is recommended.  
When armed, the alarm will be triggered if:  
the hood, tailgate or any door is opened.  
a battery cable is disconnected.  
the alarm siren is disconnected.  
Do not attempt to repair or alter any of the  
components in the alarm system yourself.  
Any such attempt could affect the terms  
and conditions of your insurance policy.  
Alarm signals  
The following occurs if the alarm is triggered:  
A siren will sound for 30 seconds or until  
the alarm is turned off.  
A red indicator light on the dashboard shows  
the status of the alarm:  
Related information  
The hazard warning flashers will flash for  
5 minutes or until the alarm is turned off.  
Indicator off - the alarm is disarmed.  
Indicator flashes once every two seconds -  
the alarm is armed.  
If the reason the alarm was triggered is not  
rectified, the alarm cycle will repeat up to 10  
The indicator flashes quickly after the  
alarm has been disabled for up to  
times15  
.
30 seconds or until the ignition is put in I  
mode – the alarm has been triggered.  
15  
Certain markets only.  
272  
 
KEY, LOCKS AND ALARM  
3. Turn the start knob clockwise and release.  
> The alarm will be disarmed.  
Arming and disarming the alarm  
The alarm is armed when the vehicle is  
Disarming the alarm  
Unlock and disarm the vehicle alarm by  
locked.  
pressing the unlock button on the remote  
key  
grip a door handle or lightly press the tail-  
gate's rubberized button16  
Turning off a triggered alarm  
.
Arming the alarm  
Lock and arm the vehicle by  
Press the unlock button on the remote key  
or put the ignition into mode I by turning  
the start knob clockwise and then releas-  
ing it.  
.
pressing the lock button on the remote  
key  
Disarming the alarm without a functioning  
remote key  
The vehicle can be unlocked and disarmed  
even if the remote key is not functioning, e.g. if  
the battery is discharged.  
.
Automatically arming and disarming  
the alarm  
Automatically arming the alarm helps prevent  
inadvertently leaving the vehicle without alarm  
protection.  
touch the marked surface on the outside  
of the door handle or the rubberized pres-  
sure plate on the tailgate16  
.
If the vehicle is equipped with both keyless  
locking/unlocking* and power tailgate*, the  
1. Open the driver's door using the detacha-  
ble key blade.  
If the vehicle is unlocked using the remote key  
(and the alarm is disarmed) but none of the  
doors or tailgate are opened within two  
minutes, the alarm will be automatically  
rearmed. The vehicle will also re-lock.  
button  
on the lower edge of the tailgate  
> This will trigger the alarm.  
can also be used to lock and arm the vehicle.  
On some markets, the alarm will be automati-  
cally armed following a slight delay after the  
driver's door has been opened and closed  
without being locked.  
To change this setting:  
1.  
Tap Settings in the center display's Top  
view.  
Location of the backup key reader in the cup holder.  
2. Place the remote key on the key symbol in  
the backup reader in the tunnel console's  
cup holder.  
2. Tap My Car Locking.  
A red LED light on the dashboard will flash every  
other second when the vehicle is locked and the  
alarm is armed.  
3.  
Select Passive Arming Deactivation to  
temporarily deactivate the function.  
16  
Vehicles with keyless locking and unlocking*.  
}}  
* Option/accessory. 273  
 
KEY, LOCKS AND ALARM  
||  
Related information  
274