Do it yourself -> Replacing light bulbs for Your Volkswagen Golf 4 Door 2023

Automatic car washes and vehicle care prod-  
ucts can leave a wax residue on all glass surfa-  
ces, which can cause the windshield wipers to grab  
and squeak. Remove these wax residues with a spe-  
cial cleaner or cleaning cloths.  
Never replace a light bulb unless you are famili-  
ar with all of the necessary procedures. In par-  
ticular, never remove a headlight unless you  
know exactly how to carry out the job and have  
the correct tools and light bulbs.  
·
·
If you are uncertain about what to do, have the  
work performed by an authorized Volkswagen  
dealer, an authorized Volkswagen Service Facili-  
ty, or another qualified workshop. Serious per-  
sonal injury may result from improperly per-  
formed work.  
Replacing light bulbs  
Introduction  
We strongly recommend that you always have  
headlights and H7 bulbs replaced by a qualified  
technician.  
·
·
Changing a light bulb requires a certain amount of  
skill. Therefore, Volkswagen recommends having the  
light bulb changed by an authorized Volkswagen  
dealer or an authorized Volkswagen Service Facility.  
Special training and knowledge are generally re-  
quired when other vehicle parts must be disassem-  
bled to replace a bulb.  
Do not touch the glass of light bulbs with your  
bare hands. Fingerprints left on the bulb evapo-  
rate due to the heat when the bulb is switched  
on and cause the reflector to “cloud.”  
There are sharp edges on and around the head-  
light housing in the engine compartment and  
the rear light housing. Wear hand protection if  
you replace bulbs.  
·
You should always keep a box in the vehicle with all  
the replacement bulbs required for traffic safety.  
Replacement bulbs are available from your author-  
ized Volkswagen dealer or authorized Volkswagen  
Service Facility. The laws of some countries explicitly  
require you to have replacement bulbs in the vehicle.  
NOTICE  
After replacing a headlight bulb or other light bulb,  
always make sure that the rubber covers or plastic  
caps have been properly and securely reinstalled to  
help prevent water from getting into the electrical  
connections and the headlight housing and damag-  
ing the electrical system.  
Driving with outside lights that do not work may be  
against the law.  
Additional light bulb specifications  
Some factory-installed light bulbs in the headlights  
may have different specifications than conventional  
light bulbs. Specifications are on the glass bulb or on  
the metal base.  
Individual LEDs cannot be replaced. Contact  
your authorized Volkswagen dealer or author-  
ized Volkswagen Service Facility for assistance.  
WARNING  
Crashes and other accidents can happen when you  
cannot see the road ahead and when you cannot  
be seen by other motorists.  
Tips and troubleshooting  
Please read the introductory information and  
WARNING  
heed the Warnings and Notice  
230.  
and on page  
Improper replacement of burned out headlights  
and other light bulbs can cause serious personal  
injury.  
When the ignition is switched on, several warning  
and indicator lights come on briefly for a function  
check. They go out after a few seconds.  
·
fore doing any work in the engine compartment  
→ page 241, In the engine compartment. The  
engine compartment of any motor vehicle is  
a potentially dangerous area, and work in this  
area can lead to serious personal injury.  
An exterior light is not working properly  
If the indicator light comes on, at least one of the  
exterior vehicle lights is not working.  
H7 bulbs are under high pressure and can ex-  
plode if handled improperly.  
·
— See an authorized Volkswagen dealer, an author-  
ized Volkswagen Service Facility, or other quali-  
fied workshop to replace the light that isn't work-  
ing.  
Always let a burned out light bulb cool down  
before replacing it.  
·
230  
Do it yourself  
 
Failure of a single LED within a taillight is not  
indicated. However, the indicator light will  
the ignition, and remove the key from the ignition  
switch (if applicable) before replacing a fuse.  
light up if all LEDs fail.  
If a fuse is replaced with a fuse with higher am-  
perage, this can also cause damage at different  
locations in the electrical system.  
·
·
Open fuse boxes must be protected from dirt and  
moisture. Dirt and moisture in fuse boxes can  
cause damage to the electrical system.  
Replacing fuses  
Introduction  
Due to ongoing development of the vehicle, config-  
uration-dependent allocation of fuses and the com-  
bined fuse protection of multiple loads with one  
fuse, an up-to-date overview of the fuse location  
per load is not possible at the time of printing. De-  
tailed information regarding fuse box layout is avail-  
able from authorized Volkswagen dealers and au-  
thorized Volkswagen Service Facilities.  
Fuses in the vehicle  
Please read the introductory information and  
heed the Warnings and Notice  
231.  
and on page  
In general, one fuse can protect several loads. One  
load can also be protected by several fuses.  
Find out why the fuse blew and correct the problem  
before replacing a blown fuse. If a newly replaced  
fuse blows again after a short time, the electrical  
system should be checked by an authorized Volks-  
wagen dealer or an authorized Volkswagen Service  
Facility.  
WARNING  
High voltage systems in the engine compartment  
can cause electrical shock, severe burns, and even  
death!  
Fig. 156 On the driver side in the instrument panel:  
Removing the storage compartment to access fuses.  
Never touch ignition cables. Never touch other  
·
components of the high voltage electronic igni-  
tion system.  
Accessing fuses in the instrument panel  
Avoid short circuits in the electrical system.  
·
— Open the storage compartment next to the steer-  
ing wheel and remove any contents.  
WARNING  
To remove: Pull the lower part of the storage  
compartment straight out (in the direction of the  
arrow → fig. 156) and remove the compartment  
from the bottom. This action may require moder-  
ate force.  
Using the wrong fuse, using a blown fuse that has  
been repaired, and using metal objects in place of  
fuses to complete the electrical connection in the  
circuit can cause fires and serious personal injury.  
Never replace a fuse with one that has a higher  
·
To install: Fit the storage compartment on the  
hinges at the bottom of the opening. Guide the  
storage compartment into the instrument panel  
by pushing in the direction opposite of the arrow  
fig. 156 until it latches into place.  
amp rating. Replace a blown fuse only with  
a fuse of the same amperage (same color and  
same imprint) and same overall size.  
Never repair fuses.  
·
·
Never replace fuses with a metal strip, a paper  
clip, or a similar object.  
NOTICE  
To help prevent vehicle damage, be careful when  
removing the storage compartment and be sure  
to reinstall it properly.  
NOTICE  
To help prevent damage to the electrical system,  
·
switch off all lights and accessories, switch off  
Replacing fuses  
231