Vision -> Windshield wipers and washer for Your Volkswagen Golf 4 Door 2023

the sensitivity of the rain sensor (vehicles with  
a rain sensor).  
Vision  
Windshield wipers and washer  
Windshield wiper lever  
Move the lever to the desired position  
fig. 81 , →  
:
G
Intermittent wiping for the rear window. The  
wiper wipes about every 6 seconds.  
H
Press the lever forward as far as it will go to  
activate the rear window washers, then release  
to stay in intermittent wiping mode (position  
G ). Pull the lever toward the steering wheel to  
turn the rear wiper off.  
If the front wipers are on, the rear wiper switches on  
automatically when backing up.  
— This feature can be turned on and off in the Vehicle  
settings menu in the Infotainment system  
→ page 26, Infotainment system operation and  
displays.  
WARNING  
Fig. 80 Operating the front windshield wipers.  
Windshield washer fluid without enough frost pro-  
tection can freeze on the windshield and reduce  
visibility.  
Use the windshield washer system with enough  
frost protection for winter temperatures.  
·
Never use the windshield wipers/washers when  
·
it is freezing without first defrosting the wind-  
shield. The washer solution may freeze on the  
windshield and reduce visibility.  
WARNING  
Worn or dirty wiper blades reduce visibility and in-  
crease the risk of accidents and severe injuries.  
Fig. 81 Operating the rear wiper.  
Always replace wiper blades that are worn,  
damaged, or do not keep the windshield clear  
→ page 228, Windshield wiper blades.  
·
The windshield wipers work only if the ignition is  
switched on and the engine hood is closed.  
Move the lever to the desired position  
NOTICE  
fig. 80 , →  
:
To help prevent damage to the wiper blades and the  
wiper motor when it is cold outside, always make  
sure that blades are not frozen to the windshield be-  
fore switching on the ignition. Using the service po-  
sition can be helpful in cold weather so the wipers  
do not freeze to the windshield → page 228, Wind-  
shield wiper service position.  
A
B
Wiper switched off.  
Intermittent wiping for the front windshield.  
Rain sensor active (if equipped).  
C
D
E
Slow wiper speed.  
Fast wiper speed.  
x One-tap wiping – brief wiping. Hold the lever  
down longer to wipe more often.  
If the ignition is switched off while the wipers are  
·
running, the wipers will continue at the same  
wiping speed when the ignition is switched on  
again. Frost, ice, snow, leaves, and other objects  
on the windshield can damage the wipers and the  
wiper motor.  
F
1
Pull the lever toward the steering wheel to  
activate the front windshield washers, then re-  
lease.  
Switch for adjusting the windshield wiper in-  
terval settings (vehicles without a rain sensor) or  
Remove snow and ice from the wipers before you  
begin driving.  
·
Windshield wipers and washer  
119  
   
If the wiper blades freeze to the windshield, loos-  
en them carefully. Volkswagen recommends using  
a deicing spray.  
·
NOTICE  
Never switch on the windshield wipers when the  
windshield is dry because the windshield can be  
scratched.  
When the vehicle is not moving, the wiper  
speed changes temporarily to the next lower  
speed.  
Fig. 83 Inside the front windshield above the inside  
mirror: Sensitive rain sensor surface (arrows).  
Certain settings are automatically saved by  
the driver personalization feature → page 30,  
Driver personalization.  
When switched on, the rain sensor automatically  
shortens or lengthens the time between wiping in-  
tervals depending on how hard it is raining →  
.
Activating and deactivating the rain sensor  
Windshield wiper functions  
Push the lever to the desired position → fig. 82:  
Heated washer nozzles (if equipped)  
Position A : Rain sensor off (windshield wiper  
When the ignition is switched on, the heat applied  
to the washer nozzles is automatically regulated de-  
pending on the outside air temperature. The heating  
thaws frozen washer nozzles, but not the fluid sup-  
ply hoses.  
lever home position).  
ing as needed.  
After switching the ignition off and back on again,  
the rain sensor stays on and works again when the  
wiper lever is in position B .  
Wiper performance during intermittent wiping  
Speed-dependent interval control: The higher the  
vehicle speed, the faster the wipers move.  
The automatic wipe function of the rain sensor can  
be turned on and off in the Vehicle settings menu in the  
Infotainment system → page 26, Infotainment sys-  
tem operation and displays.  
Rain sensor  
Setting the rain sensor's sensitivity  
The rain sensor's sensitivity can be adjusted manual-  
ly → fig. 82 1 , →  
.
— Move switch to the right – high sensitivity.  
— Move switch to the left – low sensitivity.  
WARNING  
The rain sensor cannot always recognize rain and  
activate the wipers.  
Switch the wipers on manually when water on  
the windshield reduces visibility.  
·
Fig. 82 Windshield wiper lever: Adjusting the rain sen-  
sor  
1 (if equipped).  
Tips and troubleshooting  
When the ignition is switched on, several warning  
and indicator lights come on briefly for a function  
check. They go out after a few seconds.  
120  
Vision  
     
itself to respond to the sensitive surface's re-  
duced detection zone. Depending on the size of  
the chip, the sensor's reaction pattern may or may  
not change.  
Windshield washer fluid level too low  
Your vehicle may be equipped with a yellow indica-  
tor light that comes on when the windshield washer  
fluid level is low.  
To remove wax and coats of polish safely, Volkswa-  
gen recommends using an alcohol-based windshield  
cleaner.  
Refill windshield washer reservoir at the next oppor-  
tunity → page 245, Windshield washer fluid.  
WARNING  
Rain and light sensor malfunction  
Failure to heed warning lights or other warnings  
can result in a collision and serious personal injury.  
The wipers do not switch on automatically if it rains,  
and the yellow indicator light comes on.  
Never ignore warning lights or text WARNINGS.  
·
·
— Switch the ignition off and on again.  
Always stop the vehicle as soon as it is safe to  
do so.  
— If the indicator light comes on again and stays on,  
contact an authorized Volkswagen dealer or an  
authorized Volkswagen Service Facility  
→ page 120, Rain sensor.  
NOTICE  
Failure to heed warning lights or text WARNINGS  
can result in vehicle damage.  
Windshield wiper malfunction  
If there is something on the windshield, the  
wiper will try to wipe it away. If it continues to  
block the wiper, the wiper will stop moving. Remove  
the obstacle and switch the wiper on again.  
light comes on.  
— Switch the ignition off and on again.  
— If the indicator light comes on again and stays on,  
contact an authorized Volkswagen dealer or an  
authorized Volkswagen Service Facility  
→ page 120, Rain sensor.  
Mirrors  
If there are changes in the way the rain sensor  
Introduction  
The rain sensor may misread what is happening in  
the detection zone of its sensitive rain-sensor sur-  
face fig. 83 (arrows) and not work for a number of  
reasons, which may include:  
The outside mirrors and the inside mirror help you  
see and adapt your driving to traffic behind you. Re-  
member that the inside and outside rearview mirrors  
will not show everything behind you. There can be  
blind spots. Blind spots can be significantly larger if  
the mirrors are not properly adjusted.  
Worn out wiper blades: Worn out wiper blades  
may leave a film of water or wiping streaks; this  
can cause the wipers to run longer, to wipe more  
often, or to wipe continuously at high speed.  
For your driving safety, it is important that you  
properly adjust the outside mirrors and the inside  
Insects: Insects hitting the windshield may trigger  
the wipers.  
mirror before you start driving →  
.
Looking in the exterior mirrors and the interior mir-  
ror does not allow the driver to see the entire side  
and rear area of the vehicle. The area that cannot be  
seen is known as the blind spot. There may be an-  
other vehicle, pedestrian, or object in the blind spot.  
Salt streaks: Salt streaks on the windshield from  
winter driving can cause wiping more often or  
continuously on glass that is almost dry.  
Dirt: Caked-on dust, wax, any other buildup on  
the windshield (lotus effect), or car-wash deter-  
gent residue can lower the rain sensor's sensitivi-  
ty and cause it to react too slowly or not at all.  
Clean the rain sensor's sensitive surface → fig. 83  
(arrows) regularly and check the wiper blades for  
wear or damage.  
WARNING  
Adjusting mirrors when the vehicle is moving can  
cause driver distraction, accidents, and serious  
personal injury.  
Always adjust the rearview mirrors when the  
vehicle is not moving.  
·
Crack or chip in the windshield: If a stone hits and  
chips the windshield while the rain sensor is on,  
this will trigger a wiper cycle. After that, the rain  
sensor will recognize the change and recalibrate  
Always be aware of what is happening around  
the vehicle when changing lanes, passing, turn-  
·
Mirrors  
121